Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: katar83
Showing results 1 to 25 of 129
Search took 0.02 seconds.
07-17-2019, 11:44 PM
Replies: 17
Views: 693
Posted By katar83

I'm always baffled with american cars actually...

I'm always baffled with american cars actually displaying coil misfire errors. I had so many random misfires in my ownership of a few x300 and never seen such code, even when the coil was clearly...
07-15-2019, 03:27 AM
Replies: 7
Views: 870
Posted By katar83

Found couple of pics from my recent work on this ...

Found couple of pics from my recent work on this

Actually you have to push the bush from the front as there is no space at the front for a large socket(there is at the rear)
...
07-05-2019, 05:32 AM
Replies: 7
Views: 870
Posted By katar83

Hacksaw or bolt and sockets method then.

Hacksaw or bolt and sockets method then.
07-05-2019, 05:11 AM
Replies: 7
Views: 870
Posted By katar83

You drill in the rubber between inner and outer...

You drill in the rubber between inner and outer sleeve with progressively bigger drills. At 10mm drill it should split the outer sleeve in two and then hammers out fairly easy. You press the bush...
07-04-2019, 05:25 PM
Replies: 7
Views: 870
Posted By katar83

I did my left side twice now, you will need a...

I did my left side twice now, you will need a long bolt with some thrust bearings and couple 1/2 sockets(can't remember size), if not for removing then for pressing the new one in. They are a pig to...
06-21-2019, 08:19 PM
Replies: 3
Views: 1,178
Posted By katar83

Nah, it means that the plug under left wheel arch...

Nah, it means that the plug under left wheel arch liner at the front is corroded. Remove the liner around the bumper and you'll see a large plug/socket. Clean each pin hole with a 1mm drill and the...
06-18-2019, 12:46 PM
Replies: 5
Views: 2,339
Posted By katar83

If your wife doesn't trust your repair, why not...

If your wife doesn't trust your repair, why not get a replacement tank?
...
06-13-2019, 03:48 PM
Replies: 8
Views: 1,494
Posted By katar83

Easy one. Crankshaft position sensor, couple...

Easy one. Crankshaft position sensor, couple spare coils, drive belt if current one in unknown condition and maybe basterd hose if you haven't changed it.
Nothing else needed really, apart from...
06-07-2019, 10:42 PM
Replies: 10
Views: 1,760
Posted By katar83

It's not slotted but as I said you can still...

It's not slotted but as I said you can still adjust it within the holes by maybe 3/4 of a millimeter. This is enough to change base TPS voltage by 0.06V maybe 0.08V and that's a difference between...
06-07-2019, 02:01 PM
Replies: 10
Views: 1,760
Posted By katar83

1800rpm means your TPS voltage is out by ~0.04V...

1800rpm means your TPS voltage is out by ~0.04V and your IACV don't even operate as ECU thinks you have a throttle slightly open. Does your throttle open and close fully without sticking?
Have you...
05-27-2019, 02:40 PM
Replies: 25
Views: 6,007
Posted By katar83

Done mine, couple of weeks ago. Truly amazing...

Done mine, couple of weeks ago. Truly amazing upgrade. My LWB doesn't come with an anti roll bar so the monobrace added a lot of rear end stability and I can highly recommend it. Its right there with...
Forum: XJS ( X27 )
05-26-2019, 02:46 AM
Replies: 12
Views: 592
Posted By katar83

Unless there is a special groove in the housing...

Unless there is a special groove in the housing for an o-ring that I never seen before, AJ16 does not need an o-ring, it will not fit, try to force one in and you will crack the thermostat housing.
05-04-2019, 04:58 PM
Replies: 6
Views: 423
Posted By katar83

I had to use heating today and checked mine at...

I had to use heating today and checked mine at full heat so to give you a good indication at how it should operate, at 'HI' setting and at ~3/4 full which is probably the hottest you can get it, if...
05-02-2019, 12:35 AM
Replies: 14
Views: 832
Posted By katar83

I was a bit worried about the cap myself but that...

I was a bit worried about the cap myself but that didn't seem to make any difference at all when fitted(counter intuitive I know but assume mainly the top bit seals) plus its possible to swap it...
05-01-2019, 04:17 PM
Replies: 14
Views: 832
Posted By katar83

Just checked and JLM12185 is used on both N/A and...

Just checked and JLM12185 is used on both N/A and S/C cars and Renault D95174 is exactly the same shape. I suspect you might have received either a wrong Renault part OR the socket on the Renault...
05-01-2019, 08:21 AM
Replies: 4
Views: 408
Posted By katar83

Plug an OBD scanner, key in position 2 so you can...

Plug an OBD scanner, key in position 2 so you can see full live data and check TPS operation range and post it here what the 'fully closed' position is, should be ~13% or 0.6V with foot off the pedal...
05-01-2019, 01:18 AM
Replies: 7
Views: 409
Posted By katar83

Same story with the Bosch ones here, only managed...

Same story with the Bosch ones here, only managed just over 100 miles on them before car started to splutter and die occasionally, then I went back to NGK, only to change them during following...
Forum: XJ40 ( XJ81 )
04-30-2019, 04:32 PM
Replies: 13
Views: 685
Posted By katar83

I didn't even bothered with the bypass on my old...

I didn't even bothered with the bypass on my old 40 and XJS and simply removed the oil cooler block entirely and bolted oil filter housing directly to the block using shorter bolts. Worked/works...
04-30-2019, 02:44 PM
Replies: 11
Views: 672
Posted By katar83

Since they bolt fine to a 40, they will also bolt...

Since they bolt fine to a 40, they will also bolt to an x300. No problems on XJS at all.
...
04-30-2019, 04:36 AM
Replies: 11
Views: 672
Posted By katar83

They are indeed DB7 wheels, I have a set on my...

They are indeed DB7 wheels, I have a set on my TWR XJS, they look even better on it than on a 40 or 300.
04-28-2019, 03:21 AM
Replies: 6
Views: 423
Posted By katar83

The pump itself is pretty awful on these cars,...

The pump itself is pretty awful on these cars, I'm surprised you didn't replace/fix yours yet? Brushes on these will usually last only to just over 100k miles and the pump will stop. Propeller in the...
Forum: XJ40 ( XJ81 )
04-17-2019, 06:08 AM
Replies: 4
Views: 366
Posted By katar83

1990 car will have an IR keyfob, pretty much...

1990 car will have an IR keyfob, pretty much impossible to get a replacement fob now, plus you'd need to match and solder key sequence. It is however possible to fit in an aftermarket RF keyfob...
03-29-2019, 09:34 AM
Replies: 12
Views: 921
Posted By katar83

It can. In this case though, sluggish car...

It can.

In this case though, sluggish car will most likely mean TPS out of adjustment due to stretched out linkage. Mine was showing 4.2V at full open throttle when it should be showing as close...
03-16-2019, 07:38 PM
Replies: 749
Views: 74,910
Posted By katar83

1. Finished refurbishing calipers 2. Started...

1. Finished refurbishing calipers
2. Started painting rear a-frame that I cleaned out using electrolysis some time ago
3. Put the monobrace from x308 into the electrolysis tank as I bought it quite...
Forum: XJS ( X27 )
03-14-2019, 10:16 AM
Replies: 9
Views: 558
Posted By katar83

Just undo the jubilee clip, pull the hose a bit...

Just undo the jubilee clip, pull the hose a bit further, even half a cm will do and tighten it up before the crack, you can even use a 2nd jubilee clip if you worried and keep this one to hold...
Showing results 1 to 25 of 129
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.