Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: paddyx350
Showing results 1 to 25 of 60
Search took 0.12 seconds.
05-26-2019, 10:25 PM
Replies: 40
Views: 3,124
Posted By Don B

Hi Chris, I haven't thought this through...

Hi Chris,

I haven't thought this through like you have, but it does seem that your symptoms could be caused by an obstruction in the left-to-right crossover line, or an obstruction of the suction...
05-18-2019, 01:17 PM
Replies: 7
Views: 483
Posted By Rancheroguy

Just in case, you may want to test the battery's...

Just in case, you may want to test the battery's charge at the terminals following an overnight wait. That is how I finally found my weakened battery. I had many small faults prior to replacing it...
05-18-2019, 12:25 PM
Replies: 40
Views: 3,124
Posted By motorcarman

The pump pressure is NOT the only determining...

The pump pressure is NOT the only determining factor in fuel/air ratio.
The injector pulse width is the ultimate arbitrator. Fuel pressure can rise and the pulse width can narrow to get the same...
05-15-2019, 09:33 PM
Replies: 40
Views: 3,124
Posted By Don B

Hi Chris, Here are the definition and...

Hi Chris,

Here are the definition and possible causes of P1235:

https://cimg8.ibsrv.net/gimg/www.jaguarforums.com-vbulletin/844x32/capture_013cdd39ada799ced2318803a79fa5d93c4338bb.jpg...
05-15-2019, 09:12 PM
Replies: 40
Views: 3,124
Posted By motorcarman

Have you tried ENGINEERING TEST MODE? You...

Have you tried ENGINEERING TEST MODE?

You can 'see' the level sensors individually as the INST PK 'sees' them.

Many more parameters included in the test mode.

bob
Forum: XJS ( X27 )
05-12-2019, 05:39 PM
Replies: 1,202
Views: 103,107
Posted By warrjon

I would conformal coat the PCB to prevent...

I would conformal coat the PCB to prevent corrosion.

Also check the motor brushes and commutator. I ended up replacing my blower because the commutator was badly worn.
05-01-2019, 02:17 PM
Replies: 7
Views: 483
Posted By meirion1

Which DTC's did you have? I would clear the...

Which DTC's did you have?

I would clear the codes and see if they reappear.

ABS and DSC and maybe the gearbox need the speed signal from the wheel sensors.

Possible wheel sensor failure (not...
04-29-2019, 06:51 PM
Replies: 9
Views: 470
Posted By Emmakitty

Knock sensor issues- be sure to check this

Just did the dreaded valley hose on the 2004 Xjr. Thanks to the wealth of help and info here everything went rather smoothly 🙂 However, on the first fire up I got the "restricted performance" msg. ...
04-17-2019, 09:40 AM
Replies: 17
Views: 1,764
Posted By frankc

Hi Paddy. I had the same problem. Fiddled...

Hi Paddy. I had the same problem. Fiddled with stuff it went out and then 6 months later it came back again. But I think I have solved it. So the next time you get the 2 2 fault take a look at...
03-26-2019, 03:57 PM
Replies: 14
Views: 1,252
Posted By griser

Faceplate info. There ya go.

Faceplate info.

There ya go.
03-16-2019, 07:43 PM
Replies: 3
Views: 516
Posted By Wingrider

Have not had the pleasure of replacing the rear...

Have not had the pleasure of replacing the rear shocks yet.
But have done the fronts with out disconnecting the battery.
The car rose back up when placed on the floor, then starting the motor.
03-16-2019, 05:32 PM
Replies: 3
Views: 516
Posted By meirion1

You will not need to recalibrate the height...

You will not need to recalibrate the height senors.

The idea is to replace the strut while the air suspension is" not looking".

I would lower car to the ground completely and then start it up...
03-09-2019, 09:24 AM
Replies: 2
Views: 481
Posted By Don B

I haven't installed the Comfort Bilsteins on the...

I haven't installed the Comfort Bilsteins on the rear of an XJR, but I have installed them on the front of an XJR and they were just fine. If you're not an aggressive driver, you may even prefer the...
02-18-2019, 08:38 AM
Replies: 2
Views: 401
Posted By 310jag

Brute force. Raise the headrest to its...

Brute force.

Raise the headrest to its highest position, grab the two chrome rods, and pull up. I've found the best position to do this in is actually sitting in the rear seat with the front...
12-03-2018, 05:32 PM
Replies: 17
Views: 9,835
Posted By jamdub

Yes I understand that, but so many people do...

Yes I understand that, but so many people do searches and come to these old threads - just wanna add my 2 cents just in case.
11-12-2018, 03:46 PM
Replies: 40
Views: 2,734
Posted By Blairware

I think I got you - Had this happen on my 06 XJ8L...

I think I got you - Had this happen on my 06 XJ8L - Its VERY likely the PCM is as stated above. The drain right under the cabin air filter gets blocked with leaves and debris. Then ONE good car wash...
10-18-2018, 03:21 PM
Replies: 15
Views: 1,358
Posted By Sean W

Yes they have liquid in them

Yes they have liquid in them
10-17-2018, 08:51 PM
Replies: 7
Views: 8,890
Posted By Don B

Hi EsRay, Yes the Technical Guide is...

Hi EsRay,

Yes the Technical Guide is different from the Workshop Manual. See pdf pages 90-91 of the document below for the N/A diagram:

Jaguar X350 Technical Guide 2004-2005...
10-15-2018, 11:38 PM
Replies: 3
Views: 421
Posted By dwdooley

YES .... You have to remove the seat. At the...

YES .... You have to remove the seat.
At the rear of the jack screw for the up/down motor for the rear of seat base is a "STOP" screw with a large thick flat stop washer.
Mine broke off and a part...
08-31-2018, 01:09 PM
Replies: 14
Views: 768
Posted By Slug

Lightbulb Locked out of Trunk

Looks like I'm going to be installing my THIRD trunk lock actuator assembly on my 2004 XJ8. When I bought the car in 2015 the motor was making a grinding noise, but having replaced this on my...
08-02-2018, 04:39 PM
Replies: 9
Views: 1,798
Posted By LeapOfFaith

I have found over the years with many cars that...

I have found over the years with many cars that the investment in time and money to create a system that bests the factory tuning is similar to what it would cost to upgrade the entire car to one...
07-31-2018, 04:03 PM
Replies: 9
Views: 1,798
Posted By oilstain

I should have gone with the Bit Ten, I wound up...

I should have gone with the Bit Ten, I wound up going with a 360.3 which has been problematic. Gave me lots of channels to work with though, so that's nice.

I'm impressed with the doors on this...
07-31-2018, 05:44 AM
Replies: 9
Views: 1,798
Posted By caldoofy

Few things from my experience here, To get...

Few things from my experience here,

To get the factory rear deck subs to work better go into DSP on the touch screen and select front option this will increase their output.

Firstly the door...
07-06-2018, 10:36 AM
Replies: 4
Views: 508
Posted By Aix

Good luck, we have the same weather in Germany,...

Good luck, we have the same weather in Germany, my Jag has the same problem, and my AC service last week with evac and refill didn't help, I'm still being baked in the cat.
The connectors are quite...
07-06-2018, 09:56 AM
Replies: 4
Views: 508
Posted By JagV8

Nothing special. A good a/c place should extract...

Nothing special. A good a/c place should extract & weigh the gas, check vacuum, refill, etc.
Showing results 1 to 25 of 60
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.