Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

Notices
 
Search: Posts Made By: baxtor
Showing results 1 to 25 of 498
Search took 0.14 seconds.
Today, 06:39 AM
Replies: 4
Views: 228
Posted By baxtor

ABS module solder joint fractured maybe. Search...

ABS module solder joint fractured maybe. Search will bring up plenty of hits, relatively easy fix.
Can you vouch for the battery?
03-06-2019, 01:49 PM
Replies: 8
Views: 457
Posted By baxtor

You say "metal" surround. Just in case you have...

You say "metal" surround. Just in case you have an aftermarket metal gear selector surround, the switches may in fact be held in place by a saddle and two screws, mine is.
Forum: XJS ( X27 )
02-25-2019, 05:42 AM
Replies: 21
Views: 1,033
Posted By baxtor

It bothers me more than others but next time you...

It bothers me more than others but next time you have one of the push on fittings apart run your finger over the barbs. Clamping a high pressure fuel hose down on such a sharp edge is just another...
02-24-2019, 11:05 PM
Replies: 21
Views: 1,312
Posted By baxtor

It's hardly a unique feature, probably more...

It's hardly a unique feature, probably more interference engines out there than not.
Forum: XJS ( X27 )
02-24-2019, 09:23 PM
Replies: 21
Views: 1,033
Posted By baxtor

Doug has pretty well covered it but the deeper...

Doug has pretty well covered it but the deeper ferrules, at least here are generally available from farm equipment/ tractor type outlets.
Forum: XJS ( X27 )
02-21-2019, 12:24 AM
Replies: 21
Views: 757
Posted By baxtor

Running this trans in my '89 through an...

Running this trans in my '89 through an aftermarket TCU and it definitely starts off in 1st.
Forum: XJS ( X27 )
02-20-2019, 01:45 PM
Replies: 5
Views: 316
Posted By baxtor

It could be that there is only 1 DAY difference...

It could be that there is only 1 DAY difference in build depending on when it rolls over. I imagine there could be various legitimate reasons for one car to frog leap another in the numbering, quite...
Forum: XJS ( X27 )
02-19-2019, 04:16 AM
Replies: 20
Views: 760
Posted By baxtor

The solenoids can be levered out a little at a...

The solenoids can be levered out a little at a time alternating at each end. There is a small plunger return spring arrangment in each cavity you need to take note of and be careful on reassembly so...
Forum: XJS ( X27 )
02-16-2019, 10:45 PM
Replies: 20
Views: 760
Posted By baxtor

Kids can keep their organs. New rubber bellows...

Kids can keep their organs. New rubber bellows should cost around $20.00 the rest can be rebuilt. Start with new bellows. Test for solenoid and valve seal function can be carried out on the bench...
Forum: XJS ( X27 )
02-16-2019, 03:53 PM
Replies: 20
Views: 760
Posted By baxtor

Looks like it has had a hard life. I would...

Looks like it has had a hard life. I would suggest a complete strip down to check condition of valve seals, check that wiring and renew the bellows.
Forum: XJS ( X27 )
02-15-2019, 01:53 AM
Replies: 27
Views: 15,844
Posted By baxtor

In case you didnt notice, the post you quoted is...

In case you didnt notice, the post you quoted is more than 5 years old as is triton's last activity.
02-10-2019, 11:47 PM
Replies: 28
Views: 1,977
Posted By baxtor

I am not familiar with the set up your car has...

I am not familiar with the set up your car has Billy, it was more a general observation. Maybe the Jag system is a cut above the rest or you use it as should be done. The point I was meaning to make...
02-10-2019, 04:05 PM
Replies: 28
Views: 1,977
Posted By baxtor

There is a down side to DRL's in that too many...

There is a down side to DRL's in that too many drivers think they have lights on at dawn and dusk simply because of DRL's, they do not in fact have any lights on at the rear.
02-09-2019, 03:29 PM
Replies: 20
Views: 1,678
Posted By baxtor

l think you need JLM20689. This is confirmed by...

l think you need JLM20689. This is confirmed by jaguar classic parts lookup. Out of curiosity l checked and they are available from Jag, are you sitting down... $1304.69AUD each.
02-08-2019, 03:20 AM
Replies: 3
Views: 452
Posted By baxtor

There is no connection between the exhaust and...

There is no connection between the exhaust and the electrical system on the X100. Your forum references may be for later models with active exhaust systems.
Forum: XJS ( X27 )
02-02-2019, 08:47 PM
Replies: 7
Views: 389
Posted By baxtor

Probably more than one way to skin this cat but...

Probably more than one way to skin this cat but FYI what l did was cut the green/ brown wire running from a/c control module (pin 20) to compressor relay and accessible by removing R/H console...
Forum: XJS ( X27 )
01-30-2019, 03:34 AM
Replies: 29
Views: 888
Posted By baxtor

Try this.

Try this.
Forum: XJS ( X27 )
01-27-2019, 03:19 PM
Replies: 16
Views: 504
Posted By baxtor

I needed to rebuild mine but l was able to reuse...

I needed to rebuild mine but l was able to reuse the venturi section and changed out the longer section with off the shelf steel bundy tube.
All the joints will sweat apart but be careful to...
01-25-2019, 03:12 PM
Replies: 4
Views: 406
Posted By baxtor

Yes the wheel centre needs to be removed in order...

Yes the wheel centre needs to be removed in order to remove and replace the trim.
01-22-2019, 04:33 AM
Replies: 17
Views: 4,391
Posted By baxtor

I quoted a post and replied to a comment in that...

I quoted a post and replied to a comment in that post, are we now treading such a narrow path.
01-21-2019, 09:45 PM
Replies: 17
Views: 4,391
Posted By baxtor

What size tyres you running? I'm on 20 inch and...

What size tyres you running?
I'm on 20 inch and found a huge range, pretty much all of them rated 99Y. which is rated to 300kmh.
Forum: XJS ( X27 )
01-20-2019, 05:18 AM
Replies: 46
Views: 3,125
Posted By baxtor

I've seen them here in Oz asking in the 80-90K...

I've seen them here in Oz asking in the 80-90K AUD. Either dreamers or there really are people with more money than sense.
Forum: XJS ( X27 )
01-20-2019, 05:07 AM
Replies: 24
Views: 3,656
Posted By baxtor

https://cimg5.ibsrv.net/gimg/www.jaguarforums.com-...

https://cimg5.ibsrv.net/gimg/www.jaguarforums.com-vbulletin/1120x2000/20180523_173401_1_resized_1d47e41b3834952978c88a7fb7efc16bb9e45994.jpg

Greg
Jig is shown in pic along with the poly and...
Forum: XJS ( X27 )
01-19-2019, 04:22 PM
Replies: 24
Views: 3,656
Posted By baxtor

Rebuilt mine 5 years ago using a simple jig and...

Rebuilt mine 5 years ago using a simple jig and heat cured polyurathane, been trouble free ever since.
01-19-2019, 04:14 PM
Replies: 19
Views: 1,294
Posted By baxtor

A little clarification of what is meant by...

A little clarification of what is meant by "disassembling" might be needed.
The trim rings are retained in place by the wheel centre and a lip on inner edge of trim and unless some modification is...
Showing results 1 to 25 of 498
 


 
Forum Jump

Advertising
Featured Sponsors
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.