Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: John Nevets
Showing results 1 to 25 of 123
Search took 0.01 seconds.
06-08-2019, 09:47 PM
Replies: 3
Views: 470
Posted By John Nevets

Thanks for the suggestions guys. Just to...

Thanks for the suggestions guys. Just to clarify, since the picture doesn’t really show it, this is the lower left hand side of the block, and I thought the lines went to the radiator closest to...
06-07-2019, 05:51 PM
Replies: 3
Views: 470
Posted By John Nevets

Transmission Cooler lines and Pully?

Ok, I had just finished doing a shake down run in the car, to make sure my transmission fluid change was now good. And I think it is, when I found a bigger issue. I heard a bit of a belt squeak when...
06-07-2019, 05:29 PM
Replies: 26
Views: 1,951
Posted By John Nevets

So I finally got back on this project. I got...

So I finally got back on this project. I got home late on Tuesday, and procrastinated digging into this until this morning. I think I was a bit afraid of what I'd find. Popped off the cap, and...
05-31-2019, 02:35 PM
Replies: 4
Views: 628
Posted By John Nevets

If I understand you correctly you want to make a...

If I understand you correctly you want to make a tape loop, that way it would run continuously, and your aux would be able to as well. The only down side would be the tape deck itself might wear out...
05-29-2019, 09:13 PM
Replies: 4
Views: 761
Posted By John Nevets

If you have the HID’s, yes there is a ballast...

If you have the HID’s, yes there is a ballast mounted to the bottom of the light fixture housing itself. You have to remove the whole thing to get access, but then it is not too bad.

But if...
05-29-2019, 09:02 PM
Replies: 26
Views: 1,951
Posted By John Nevets

If you go back to my first post in this thread...

If you go back to my first post in this thread you can see where I got the tubes on Amazon. They were sold out when I checked again a few days ago, but I believe others had them as well.

I...
05-28-2019, 06:44 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Interesting. OK, I will try and remove later,...

Interesting. OK, I will try and remove later, and see what I see. What would fluid coming out of here typically mean? Would leaving it overfilled do that, or a bad seal at the bridge seal, or is...
05-28-2019, 03:12 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Well, I guess I started patting myself on the...

Well, I guess I started patting myself on the back a little too early. Went out this morning, and found a bit of a red puddle under the car. Took a while to find the actual drip, since it was going...
05-27-2019, 08:29 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Good point, and one I had thought about. The...

Good point, and one I had thought about. The only part I wasn't sure on, was running through the gears at the lower temp. I didn't know if I had done it at the recommended 30-35c if it would have...
05-27-2019, 04:26 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Well, it's done. Or, mostly done. I still have...

Well, it's done. Or, mostly done. I still have the car on jack stands, and even though I have the tools put away, and the fill nut fully torqued back down. I may double check my level one more...
05-27-2019, 07:03 AM
Replies: 10
Views: 846
Posted By John Nevets

I was out in Palo Alto a few months ago for work....

I was out in Palo Alto a few months ago for work. Had a day off, and took the back roads over the mountains to the ocean. Had a great drive, lots of windy technical driving. I was only in an...
05-26-2019, 04:32 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Thanks for the confirmation Jon. I guess I...

Thanks for the confirmation Jon.

I guess I chose to take my break at the wrong time, so I'm on another one now. After the race the underside was down to about a drip every other second or...
05-26-2019, 01:45 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Well, I got the project started a few hours ago. ...

Well, I got the project started a few hours ago. I have the pan off, on the ground underneath where it was, and letting everything keep dripping in to it. Overall so far (knock on wood) it's going...
05-24-2019, 09:26 PM
Replies: 26
Views: 1,951
Posted By John Nevets

Thanks David. I appreciate your confidence. But...

Thanks David. I appreciate your confidence. But hopefully I won't even have to crack open the valve body, or even remove the solenoids. I think all I'll have to do is remove the unit as a whole to...
05-24-2019, 08:13 PM
Replies: 26
Views: 1,951
Posted By John Nevets

So, maybe I'm not understanding locations,...

So, maybe I'm not understanding locations, because I haven't had the transmission open yet. Yes I do have a 4.2 with the zf 6hp26 transmission....
05-24-2019, 05:11 PM
Replies: 26
Views: 1,951
Posted By John Nevets

To remove the valve body on transmission fluid change, or not?

Hi folks. With the last of the parts getting here today, I'm planning on doing a transmission filter and fluid change this weekend. I'm going to be doing it "Reverend Sam style" on the floor with...
05-24-2019, 04:22 PM
Replies: 15
Views: 1,145
Posted By John Nevets

Thanks for that. I didn't want to clutter up...

Thanks for that. I didn't want to clutter up this thread any more, but since you brought it up. I've already been seeking, and getting help, all though no final resolution, in another post on lean...
05-24-2019, 03:28 PM
Replies: 44
Views: 2,662
Posted By John Nevets

Are the XK's more long, sleek, and curvy than...

Are the XK's more long, sleek, and curvy than most other sporty cars, yes. More so the X100, but the X150 as well. That's what I like about them. A lot of guys refer to their cars with female...
05-24-2019, 02:51 PM
Replies: 15
Views: 1,145
Posted By John Nevets

Thanks for confirming guys, even though it wasn't...

Thanks for confirming guys, even though it wasn't my thread. I was at harbor freight today picking up some other things (if you get the catalog the click torque wrenches are down to $12 with...
05-22-2019, 06:50 PM
Replies: 15
Views: 1,145
Posted By John Nevets

Are you getting any codes with this, or is it...

Are you getting any codes with this, or is it just what you are being told? Just as a frame of reference I have been getting some lean codes lately so I have been monitoring it pretty close, and...
05-19-2019, 08:11 PM
Replies: 428
Views: 45,931
Posted By John Nevets

Well over the last two days, I did some basic...

Well over the last two days, I did some basic maintenance; changed air filter, cleaned wheel speed sensors, and mounted front license plate. Looked at changing fuel filter, but decided to wait until...
05-18-2019, 05:16 PM
Replies: 41
Views: 2,200
Posted By John Nevets

Did some work this afternoon. But don't fully...

Did some work this afternoon. But don't fully know results yet. I took off the top of the air filter box, and found a plastic push pin floating around in there, figured out where it went and...
05-16-2019, 06:27 AM
Replies: 41
Views: 2,200
Posted By John Nevets

I have air and fuel filters coming on Saturday,...

I have air and fuel filters coming on Saturday, and when I find some time I will start working through the lists. I do appreciate that info.

I’d like to think I’m mechanically decent, but I’ll...
05-15-2019, 06:01 AM
Replies: 41
Views: 2,200
Posted By John Nevets

Sorry, I had written that up in the post that got...

Sorry, I had written that up in the post that got deleted, and then forgot to reinclude it in the new one. At a warmed up idle of 650 rpm, then revved up to 1650, and 3400 (each held for at least...
05-15-2019, 05:21 AM
Replies: 59
Views: 3,510
Posted By John Nevets

Yes S2art, that is a good one. ;-)

Yes S2art, that is a good one. ;-)
Showing results 1 to 25 of 123
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.