Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: warrjon
Showing results 1 to 25 of 500
Search took 0.06 seconds.
Forum: XJS ( X27 )
Yesterday, 04:10 PM
Replies: 17
Views: 433
Posted By warrjon

An alternator generates 3 phase AC and has...

An alternator generates 3 phase AC and has rectifier diodes to convert the AC to DC then it has a regulator to keep the voltage between certain values approx 13-15V.

Alternator voltage will be at...
Forum: XJS ( X27 )
06-17-2019, 08:14 PM
Replies: 17
Views: 433
Posted By warrjon

If this reading is directly across the battery...

If this reading is directly across the battery terminals then the reg is almost definitely the problem.

If you run it like this you will boil the battery and it could explode if the vent does not...
Forum: XJS ( X27 )
06-17-2019, 04:47 AM
Replies: 80
Views: 5,692
Posted By warrjon

Is it repairable, what is on the other side. If...

Is it repairable, what is on the other side. If so then you can use those HTS2000 aluminium brazing rods to repair it. I repaired the aluminium flywheel cover with them, the one that holds the engine...
Forum: XJS ( X27 )
06-17-2019, 04:44 AM
Replies: 17
Views: 507
Posted By warrjon

Sorry Greg I don't have pics. My rear end still...

Sorry Greg I don't have pics. My rear end still has needle rollers. I will pulling the diff to go back to 2.88 when I put the 6.7L in I am going to install the bronze bushes then.
Forum: XJS ( X27 )
06-16-2019, 05:50 PM
Replies: 8
Views: 613
Posted By warrjon

I removed my transmission with the engine still...

I removed my transmission with the engine still in the car.

Put a jack under the trans and lower it as much as possible, this will allow you to get at the top bolts .
...
Forum: XJS ( X27 )
06-16-2019, 05:35 PM
Replies: 17
Views: 507
Posted By warrjon

You beat me to it. Norman Lutz does this to all...

You beat me to it. Norman Lutz does this to all Jaguar rear ends, it fixes the major design flaw with bearings in the fulcrum. Bearings are designed to rotate 360 not 10 like they are doing in the...
Forum: XJS ( X27 )
06-16-2019, 05:27 PM
Replies: 22
Views: 825
Posted By warrjon

The 0.6v is the test voltage from the DMM all it...

The 0.6v is the test voltage from the DMM all it is doing is checking the transistor. A transistor is an electronic switch and 0.6-0.8v turns it on.

There should be a sticker on the ECU with a...
Forum: XJS ( X27 )
06-15-2019, 10:46 PM
Replies: 22
Views: 825
Posted By warrjon

Ok I have identified the Transistor that drives...

Ok I have identified the Transistor that drives the AC clutch relay. It is a ZTX550 and I am pointing to it here.
...
Forum: XJS ( X27 )
06-14-2019, 05:31 PM
Replies: 80
Views: 5,692
Posted By warrjon

Look on the bright side - at least you did not...

Look on the bright side - at least you did not rebuild it and get it in the car before finding the crack.

I just gave away my TH400 for nothing tried to sell it and no one wanted it.
Forum: XJS ( X27 )
06-14-2019, 05:23 PM
Replies: 13
Views: 658
Posted By warrjon

Not sure what the top pic is my car does not have...

Not sure what the top pic is my car does not have that, maybe a vacuum reservoir. The bottom pic is the charcoal canister and part of the emission system.
Forum: XJS ( X27 )
06-14-2019, 05:16 PM
Replies: 22
Views: 825
Posted By warrjon

I'll dig out my spare ECU and see if I can...

I'll dig out my spare ECU and see if I can identify which transistors control the AC compressor clutch. It is rather difficult as I don't have a circuit diagram and all the traces run inside the PCB...
Forum: XJS ( X27 )
06-14-2019, 04:36 PM
Replies: 22
Views: 825
Posted By warrjon

When I replaced my heater valve I used a GM part...

When I replaced my heater valve I used a GM part off our local Commodore been there 12 years now.
...
Forum: XJS ( X27 )
06-13-2019, 07:11 PM
Replies: 22
Views: 825
Posted By warrjon

So pin 20 from the ECU only has 4-5volts on it,...

So pin 20 from the ECU only has 4-5volts on it, is that correct?

Piano shaped ECU that's the MK3 which only turns the heater tap off on full cold.
Forum: XJS ( X27 )
06-13-2019, 06:30 PM
Replies: 22
Views: 825
Posted By warrjon

Yes, or as I did before I repaired the AC use a...

Yes, or as I did before I repaired the AC use a cable tie to close the valve.
Forum: XJS ( X27 )
06-13-2019, 05:44 PM
Replies: 5
Views: 309
Posted By warrjon

Grade 8 is what you want. Most of the botls/nuts...

Grade 8 is what you want. Most of the botls/nuts are UNF 3/8 and 7/16 are used a lot.
Forum: XJS ( X27 )
06-13-2019, 05:42 PM
Replies: 22
Views: 825
Posted By warrjon

Pulling the vac line opens the tap you need to...

Pulling the vac line opens the tap you need to either add a solenoid valve inline to stop water flow or better still apply vacuum to the tap, this can be done by turning on the vacuum solenoid that...
Forum: XJS ( X27 )
06-13-2019, 04:18 PM
Replies: 22
Views: 825
Posted By warrjon

I used Dynamat, works really well. I often drive...

I used Dynamat, works really well. I often drive with AC off and windows down in summer and before the Dynamat the feet used to swelter, now I can comfortably do that with out cooking my feet. The...
Forum: XJS ( X27 )
06-13-2019, 04:13 PM
Replies: 5
Views: 309
Posted By warrjon

7/15-20 is UNF so they are the correct nuts.

7/15-20 is UNF so they are the correct nuts.
Forum: XJS ( X27 )
06-13-2019, 03:55 PM
Replies: 6
Views: 480
Posted By warrjon

Your profile does not say where you are in Oz. ...

Your profile does not say where you are in Oz.

These are the 2 places I get my parts from I got a set of 4.09 gears from JagDaim.
Cathouse Spares in Sydney 9898 1700

JagDaim in Melbourne ...
Forum: XJS ( X27 )
06-13-2019, 03:48 PM
Replies: 5
Views: 309
Posted By warrjon

Page 06-2 of the ROM has the information 7/16 UNF

Page 06-2 of the ROM has the information 7/16 UNF
Forum: XJS ( X27 )
06-12-2019, 02:46 AM
Replies: 5
Views: 892
Posted By warrjon

Is the fuel pump running? it should run for a few...

Is the fuel pump running? it should run for a few seconds when you turn the ignition on.

The fuel feed pipe runs under the car on the RH side, someone jacking the car up under the sill could crush...
Forum: XJS ( X27 )
06-11-2019, 03:40 PM
Replies: 11
Views: 602
Posted By warrjon

I would put poly in the 6 shot and rack and OEM...

I would put poly in the 6 shot and rack and OEM in the wishbone. You will not loose comfort with Poly in the 6 shot and rack,

I have poly in the upper wishbone and while it sharpens up the...
Forum: XJS ( X27 )
06-10-2019, 05:20 PM
Replies: 5
Views: 678
Posted By warrjon

The CPS will have no effect on how much fuel the...

The CPS will have no effect on how much fuel the ECU commands. The CPS tells the ECU what RPM the engine is doing and when to fire the ignition and injectors.

Fueling amount is controlled by...
Forum: XJS ( X27 )
06-08-2019, 06:20 AM
Replies: 7
Views: 654
Posted By warrjon

I split my calipers and replaced the O rings,...

I split my calipers and replaced the O rings, that was 6 years ago now. The calipers aligned with the bolts.

The O ring is just in the pic on the bottom right. Rear calipers do not have O rings as...
Forum: XJS ( X27 )
06-07-2019, 04:23 PM
Replies: 7
Views: 801
Posted By warrjon

I used a hole saw and then inserted as grommet,...

I used a hole saw and then inserted as grommet, you can see the screw inside this is the rod that opens the boot.
...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.