Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: motorcarman
Showing results 1 to 25 of 500
Search took 0.15 seconds.
Yesterday, 02:25 PM
Replies: 6
Views: 336
Posted By motorcarman

The internal harness does have different part...

The internal harness does have different part numbers for the AJ26 and AJ27 but I have installed a later gearbox (xxxxx026 into the earlier car with a xxxxxx015) and it worked OK, No Issues.

The...
07-13-2019, 08:57 PM
Replies: 8
Views: 352
Posted By motorcarman

The 1998/99 XJR are all AJ26. bob

The 1998/99 XJR are all AJ26.

bob
07-10-2019, 11:48 AM
Replies: 8
Views: 919
Posted By motorcarman

You can call Automotive Wood Restoration...

You can call Automotive Wood Restoration (http://www.maderaconcepts.com/) and see if they will tell you how it is done??

We just removed and sent the veneer to Madera Concepts when necessary. They...
Forum: XJS ( X27 )
07-09-2019, 09:08 AM
Replies: 19
Views: 1,152
Posted By motorcarman

I always thought that the oil leaks were a...

I always thought that the oil leaks were a British Mandate so as to provide year round rust protection??

bob
07-08-2019, 12:49 PM
Replies: 6
Views: 367
Posted By motorcarman

Thanks for the replies. I thought a LIKE was all...

Thanks for the replies. I thought a LIKE was all that was needed. I know nothing about TAG except we used to play that in grade school.

bob
07-08-2019, 12:46 PM
Replies: 11
Views: 550
Posted By motorcarman

The only real way to test actual oil pressure is...

The only real way to test actual oil pressure is to remove either the oil pressure switch or the oil temp sensor and use an adapter and gauge.

bob
07-07-2019, 08:32 PM
Replies: 11
Views: 586
Posted By motorcarman

I did but nobody appreciated the body strap!!! ...

I did but nobody appreciated the body strap!!!

bob
07-07-2019, 08:23 PM
Replies: 4
Views: 718
Posted By motorcarman

Looks like the security sounder?? bob

Looks like the security sounder??

bob
Forum: XJ40 ( XJ81 )
07-07-2019, 08:18 PM
Replies: 10
Views: 428
Posted By motorcarman

I would not worry about temps up to 400 or 500...

I would not worry about temps up to 400 or 500 degrees or even higher. I would not try to get it to GLOW.
I got one to 'glowing-hot' and it did not work.

I had the Jaguar parts dept in the same...
Forum: XJ40 ( XJ81 )
07-07-2019, 03:34 PM
Replies: 10
Views: 428
Posted By motorcarman

Don't heat the lock collar to 'cherry red hot'. I...

Don't heat the lock collar to 'cherry red hot'. I tried it and it fell on but would not shrink back to TIGHT.
It just fell off when it cooled.
A mildly hot collar and some 'persuasion' will...
07-07-2019, 03:27 PM
Replies: 6
Views: 367
Posted By motorcarman

I read the post and did not see anything that...

I read the post and did not see anything that warranted an alert.
I guess I will ignore it.

bob
07-07-2019, 02:43 PM
Replies: 6
Views: 367
Posted By motorcarman

I just got a forum alert about being 'tagged'

I don't understand what that means. Is that something I should worry about?
What is a 'tag' and why am I being alerted?? Never heard of this before.

bob
07-07-2019, 02:36 PM
Replies: 5
Views: 394
Posted By motorcarman

The 4.0 liter ABS modules are 'Traction Control'...

The 4.0 liter ABS modules are 'Traction Control' and EXCEPT Traction Control. They are NOT interchangeable.

bob
07-07-2019, 11:21 AM
Replies: 8
Views: 452
Posted By motorcarman

I had the 'one side is colder than the other...

I had the 'one side is colder than the other side' complaint when I worked at the dealer.
Like Thermo says, it usually turned out to be a low refrigerant charge.
The X400 is pretty sensitive about...
07-07-2019, 11:07 AM
Replies: 5
Views: 412
Posted By motorcarman

You might check the pulley support bearing. It...

You might check the pulley support bearing. It does not do as much when the clutch is engaged as the shaft bearings do most of the work.

Just a thought. Try removing the belt and grabbing the...
07-07-2019, 10:56 AM
Replies: 5
Views: 394
Posted By motorcarman

Guessing can get expensive. A proper diagnostic...

Guessing can get expensive. A proper diagnostic tool is harder to come by but it might be worth it to check the module for DTCs before 'throwing parts' at the car.

Most of the faults I've had with...
07-07-2019, 08:17 AM
Replies: 20
Views: 978
Posted By motorcarman

The VVT ACTUATOR is the device protruding through...

The VVT ACTUATOR is the device protruding through the cam cover. The CMPS is at the rear of the head.

bob
Forum: XJ40 ( XJ81 )
07-07-2019, 08:04 AM
Replies: 10
Views: 428
Posted By motorcarman

I cut through like you did but I finish with a...

I cut through like you did but I finish with a 'cold-chisel' to crack the ring.

looks good so far.

bob
07-06-2019, 08:46 PM
Replies: 16
Views: 1,172
Posted By motorcarman

I've had this problem but I don't know what car...

I've had this problem but I don't know what car you have!
(I hate mystery cars)
Before you whine about how nobody will give info about your car........... How about telling us what car you have????...
07-06-2019, 08:41 PM
Replies: 20
Views: 978
Posted By motorcarman

You need to actually 'stick-your-face' in the...

You need to actually 'stick-your-face' in the area between the power stud and the starter as well as between the starter and alt.
The short link lead between the starter and alt is part number...
07-06-2019, 09:42 AM
Replies: 7
Views: 709
Posted By motorcarman

The CKPS is on the right forward side of the...

The CKPS is on the right forward side of the engine block. The electrical connector is shown on page 40 of the S-Type powertrain into booklet S-Type POWERTRAIN_JJM101517-92.pdf

Crankshaft Position...
07-06-2019, 08:22 AM
Replies: 20
Views: 978
Posted By motorcarman

The large wire goes to the starter and then a...

The large wire goes to the starter and then a short link wire from the starter to the alt.

bob
07-05-2019, 10:00 PM
Replies: 20
Views: 978
Posted By motorcarman

Alt bad or wire issue? That wire is the...

Alt bad or wire issue?
That wire is the STARTER/ALTERNATOR link to the battery.

bob
07-05-2019, 09:56 PM
Replies: 4
Views: 805
Posted By motorcarman

I bought a few rolls of 7mm copper core wire...

I bought a few rolls of 7mm copper core wire several decades ago (packard and accel). I also have a box of high tension boots in various sizes and shapes.
The metal ends also come in different...
07-05-2019, 01:05 PM
Replies: 20
Views: 978
Posted By motorcarman

The ECM/TCM control module enclosure does not...

The ECM/TCM control module enclosure does not need to be opened.
The power stud is on the front side of the fiber bulkhead surrounding that box.
You just need to unscrew on posidrive screw and lift...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.