Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: M. Stojanovic
Showing results 1 to 25 of 500
Search took 0.08 seconds.
Yesterday, 08:27 PM
Replies: 6
Views: 248
Posted By M. Stojanovic

Yes, you could use a standard M8 bolt but its hex...

Yes, you could use a standard M8 bolt but its hex head will be 13mm. The link I provided is for the "small wrench" M8 bolts which have a flange and 10mm hex head, same as the original bolts.
Yesterday, 08:21 PM
Replies: 62
Views: 1,217
Posted By M. Stojanovic

I had the same symptom after I replaced my old...

I had the same symptom after I replaced my old failed alternator. At the same time, my positive battery cable was getting rather hot near its connection to the battery post. I replaced the cable and...
Yesterday, 04:55 AM
Replies: 6
Views: 248
Posted By M. Stojanovic

You can get those bolt here:...

You can get those bolt here: https://www.belmetric.com/8mm-c-2_1046_1048/?zenid=n845buuojee3aq3se68g8fc0g1, just select the correct length. The bolt length is measured from its tip to the underside...
07-20-2019, 09:42 AM
Replies: 23
Views: 968
Posted By M. Stojanovic

Use a "dentist's pick" with the tip at 90 deg....

Use a "dentist's pick" with the tip at 90 deg. and feel the inside of the brass bush. From the outside, there should be a step after about 3 mm where the inner diameter of the bush widens a bit....
07-19-2019, 09:33 PM
Replies: 23
Views: 968
Posted By M. Stojanovic

I have not checked the position of the o-ring on...

I have not checked the position of the o-ring on my brass bush but it should be at the inner end of the bush. The o-ring sits in a recess near the end of the bush. In any case, you should be able to...
07-19-2019, 08:43 AM
Replies: 37
Views: 2,492
Posted By M. Stojanovic

Yes, except that the description mentions "INA...

Yes, except that the description mentions "INA Case needle bearings" but the pictures do not show them. Better to clarify this with the seller.
07-18-2019, 10:29 PM
Replies: 23
Views: 968
Posted By M. Stojanovic

I keep the new brass bush and plastic collet as...

I keep the new brass bush and plastic collet as spare and, if one day I need to repair my (now still good) old connector, I will keep the old brass bush and just use the new o-ring and the plastic...
07-18-2019, 10:17 PM
Replies: 23
Views: 968
Posted By M. Stojanovic

The small vacuum hose running through the silver...

The small vacuum hose running through the silver heat shield may be for a model with different vacuum lines arrangement and you may not need to use it. Or it may be the line from the Purge Valve to...
07-17-2019, 01:30 AM
Replies: 62
Views: 1,217
Posted By M. Stojanovic

You can check it without the alternator. Just...

You can check it without the alternator. Just connect the battery (make sure that the disconnected main cable to the alternator is not touching the ground) and switch the ignition "on" (do not...
07-16-2019, 01:48 AM
Replies: 62
Views: 1,217
Posted By M. Stojanovic

They also have IN9218HD (heavy Duty) but they...

They also have IN9218HD (heavy Duty) but they don't state what the difference is.

https://store.alternatorparts.com/in9218hd---voltage-regulator.aspx
07-16-2019, 01:45 AM
Replies: 62
Views: 1,217
Posted By M. Stojanovic

If you could still start the engine after the...

If you could still start the engine after the bulbs burnouts, at least the engine ECU is fine. Don't try to start the engine again with the faulty alternator still in. You can test everything with...
07-15-2019, 11:10 PM
Replies: 2
Views: 341
Posted By M. Stojanovic

You need the hose NNE3976CA. It goes from the...

You need the hose NNE3976CA. It goes from the (blocked off) port on your TB to a small offtake on a large plastic "T" on the heater return hose. This T is to the left (looking to front of car) and...
07-15-2019, 10:44 PM
Replies: 62
Views: 1,217
Posted By M. Stojanovic

If the headlight bulbs blew so quickly, you had a...

If the headlight bulbs blew so quickly, you had a serious over-voltage coming from the alternator. This can only be due to a bad voltage regulator not controlling the voltage, i.e. having a short...
07-14-2019, 08:23 PM
Replies: 12
Views: 565
Posted By M. Stojanovic

There is no difference between XJR and XJ...

There is no difference between XJR and XJ radiators. There are some (minor probably) differences between the early radiators (up to VIN 832727) and the later ones. I do not know whether the later...
07-14-2019, 07:53 AM
Replies: 8
Views: 540
Posted By M. Stojanovic

A bigger diameter MAF alone will not reduce the...

A bigger diameter MAF alone will not reduce the vacuum much. Air will just flow faster through a restriction like the MAF. The impediment to the air flow is caused by the friction between the air and...
07-13-2019, 09:15 PM
Replies: 8
Views: 540
Posted By M. Stojanovic

The restriction by the MAF sensor is negligible...

The restriction by the MAF sensor is negligible as it is very short, especially so on a supercharged engine as the supercharger pulls more than enough air for the engine's full power. On the other...
07-13-2019, 08:49 PM
Replies: 13
Views: 550
Posted By M. Stojanovic

Obvious thing to replace is the sensor (3-way...

Obvious thing to replace is the sensor (3-way pressure switch). Then go from there.
07-13-2019, 04:46 AM
Replies: 23
Views: 968
Posted By M. Stojanovic

The strange round connector (part of the T) is...

The strange round connector (part of the T) is the one that is plugged (push-on) onto the large port on the LHS of the intake elbow. The silver heat insulated section goes (connects) to the Purge...
07-12-2019, 07:20 AM
Replies: 6
Views: 460
Posted By M. Stojanovic

X308's did not have wheel nuts with tapered base...

X308's did not have wheel nuts with tapered base as stock original. Do you have aftermarket wheels? these are the short and long stock nuts:
...
07-12-2019, 01:49 AM
Replies: 23
Views: 968
Posted By M. Stojanovic

The "breather" hose I mentioned is actually the...

The "breather" hose I mentioned is actually the PCV (Positive Crankcase Ventilation) hose. The first picture shows its connections to the LHS cam cover and to the the large port on the left side of...
07-12-2019, 01:10 AM
Replies: 15
Views: 665
Posted By M. Stojanovic

Yes, if there was no o-ring with your old...

Yes, if there was no o-ring with your old (genuine Jaguar) gasket, then if you prefer to go without an o-ring, you should get a a new genuine gasket. Otherwise, if you wish to use the aftermarket...
07-10-2019, 11:57 PM
Replies: 23
Views: 968
Posted By M. Stojanovic

My SC engine (AJ26) does not have EGR valve so a...

My SC engine (AJ26) does not have EGR valve so a small water hose from that T goes directly to the TB. If you have an EGR valve (is your engine AJ27?), then what you say is correct.


Yes, there...
07-10-2019, 11:10 PM
Replies: 15
Views: 665
Posted By M. Stojanovic

It seems that some engines had an o-ring for the...

It seems that some engines had an o-ring for the water pump and some did not. There are two o-ring sizes, 55 and 70 mm, depending on the diameter of the round opening in the block. If used, the...
07-09-2019, 10:24 PM
Replies: 15
Views: 665
Posted By M. Stojanovic

The old gasket looks pretty good on the picture....

The old gasket looks pretty good on the picture. Just clean it and clean the mating surfaces (do not scratch them) and assemble. You can use a very very thin coat of some liquid gasket sealant on it...
07-09-2019, 10:01 PM
Replies: 15
Views: 665
Posted By M. Stojanovic

The water pump has two gaskets: one between the...

The water pump has two gaskets: one between the pump halves which is not separately available (the old black gasket you have shown) and another between the pump assembly and the engine block. You...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.