Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: AllanG
Showing results 1 to 25 of 500
Search took 0.10 seconds.
06-14-2014, 12:33 PM
Replies: 25
Views: 5,654
Posted By AllanG

Shawn, I think I will try your technique first...

Shawn,
I think I will try your technique first and see. I am a bit concerned about the structural integrity as there are some pretty significant creases but it's worth a shot. The tank is about...
06-12-2014, 10:48 AM
Replies: 25
Views: 5,654
Posted By AllanG

Exact same happened to me today!!! Noticed the...

Exact same happened to me today!!! Noticed the fuel flap was sticking up and wouldn't close because the cap was too high. Whipped out the carpets and lo and behold the tank has completely collapsed...
06-05-2014, 04:10 PM
Replies: 6
Views: 1,521
Posted By AllanG

I'd say new belts would be a sensible investment....

I'd say new belts would be a sensible investment. Also I'd check and probably change the bearing in the belt idler pulley, especially if it has not been renewed in a long time.
05-29-2014, 07:48 AM
Replies: 14
Views: 1,983
Posted By AllanG

Relay is in the engine bay just in front of the...

Relay is in the engine bay just in front of the air filter housing. Your owners manual will show the exact location.

The BPM is behind the glovebox. Just remove the underscuttle and you will be...
Forum: XJS ( X27 )
05-29-2014, 06:56 AM
Replies: 10
Views: 5,615
Posted By AllanG

No you cannot use an OBDII scanner on the XJS...

No you cannot use an OBDII scanner on the XJS V12, only the 6 cylinder AJ16 95 and 96MY cars have this capability.



Correct they will not read Body, ABS etc codes. Because those codes were not...
05-28-2014, 05:41 AM
Replies: 14
Views: 1,983
Posted By AllanG

As Grant suggests a little testing is needed. ...

As Grant suggests a little testing is needed. You can look through hundreds of posts here to see that that throwing parts at a problem very often does not work.

A few mins with a voltmeter and...
Forum: XJS ( X27 )
05-27-2014, 07:01 PM
Replies: 10
Views: 5,615
Posted By AllanG

Vee, Fusion for iOS and Torque for Android are...

Vee, Fusion for iOS and Torque for Android are excellent scan tools for the money. They have a lot of capability for the money.
Forum: XJS ( X27 )
05-27-2014, 06:58 PM
Replies: 10
Views: 5,615
Posted By AllanG

I do not believe that the 95 XJS V12 had OBD-II...

I do not believe that the 95 XJS V12 had OBD-II capabilities. It was OBD-I compliant only I believe
Forum: XJS ( X27 )
05-27-2014, 06:55 PM
Replies: 8
Views: 836
Posted By AllanG

The wheels, they were, well, rouge. :)

The wheels, they were, well, rouge. :)
05-25-2014, 07:14 AM
Replies: 10
Views: 2,117
Posted By AllanG

Grant, I don't think that a blown bulb will cause...

Grant, I don't think that a blown bulb will cause the interlock to go AWOL but stranger things have happened :)

Jim, I agree with Graham that the brake switch may be the culprit. Can you hear it...
05-24-2014, 06:17 AM
Replies: 13
Views: 2,358
Posted By AllanG

If the engine was run at very lean conditions for...

If the engine was run at very lean conditions for a long time, especially at higher rpms, this raises cylinder head temps dramatically. Very bad for the engine and that would explain the cracked...
05-23-2014, 08:59 AM
Replies: 11
Views: 1,019
Posted By AllanG

You might also want to double check that you did...

You might also want to double check that you did indeed get all the air out of the front left line.
Forum: XJS ( X27 )
05-23-2014, 07:27 AM
Replies: 2
Views: 1,045
Posted By AllanG

Yep and to those I would add wiring issues, the...

Yep and to those I would add wiring issues, the switch and possibly the servo.
05-23-2014, 07:12 AM
Replies: 23
Views: 10,473
Posted By AllanG

Well it certainly sounds like your ECM is fried. ...

Well it certainly sounds like your ECM is fried. Might be difficult in the Philippines but if you can get hold of another ECM to test that would be best.

Does your car have 4 O2 sensors or just...
05-23-2014, 06:51 AM
Replies: 6
Views: 1,502
Posted By AllanG

Use an impact gun to spin the bolt then a punch...

Use an impact gun to spin the bolt then a punch to knock it out. using a spring compressor may help take some of the load off too.

Like Grant said, the spherical joint is in pretty tight and it's...
05-22-2014, 06:56 PM
Replies: 31
Views: 2,954
Posted By AllanG

Ross, My local Halfords in London let me use...

Ross,

My local Halfords in London let me use one on my sister's car free of charge. Don't know if that was a one off or common?
05-22-2014, 03:42 PM
Replies: 27
Views: 3,383
Posted By AllanG

Panagiotis, It is really much easier to take...

Panagiotis,

It is really much easier to take the engine and gearbox out together. Yes you will have to remove a few more things, drain coolant etc. but none of that is hard to do. Plus you can...
05-22-2014, 03:28 PM
Replies: 31
Views: 2,954
Posted By AllanG

Hmmm, it doesn't look like the protocol is...

Hmmm, it doesn't look like the protocol is configurable. The manual says that if you get a connection error, unplug the unit for 10 secs minimum and then retry. Have you tried that?

If you still...
05-22-2014, 10:12 AM
Replies: 31
Views: 2,954
Posted By AllanG

Dave, which model of maxi scan did you buy? Also...

Dave, which model of maxi scan did you buy? Also did it come with a manual, should be connection advice in there. If not post the model and I'll look it up.
05-22-2014, 08:21 AM
Replies: 31
Views: 2,954
Posted By AllanG

Exactly right. Sometimes these units do not...

Exactly right. Sometimes these units do not automatically find the correct protocol to connect and you have to force them to use it.

The protocol used is ISO9141 (sometimes shown as ISO9141-2)
05-21-2014, 02:32 PM
Replies: 6
Views: 1,214
Posted By AllanG

Stu, Looking at the wiring diagram, the...

Stu,

Looking at the wiring diagram, the telephone transceiver is connected to the standard jaguar radio/cassette had unit by 3 wires Purple/Red, Purple/Pink and Purple/Orange

The wiring diagram...
05-21-2014, 09:13 AM
Replies: 4
Views: 1,161
Posted By AllanG

If you think that the odor is strongest at the...

If you think that the odor is strongest at the rear of the car, I would check under the car. The feed and return pipes exit right above the diff, hard to get at but you can see if anything is...
05-21-2014, 08:46 AM
Replies: 31
Views: 2,954
Posted By AllanG

Dave, Ross is right on with his suggestions....

Dave,

Ross is right on with his suggestions. I would add just that it might be worthwhile to double check that the crank sensor plug is correctly and fully seated in the harness socket. ...
05-20-2014, 07:00 AM
Replies: 31
Views: 2,954
Posted By AllanG

Dave, Time for some troubleshooting. Have...

Dave,

Time for some troubleshooting. Have you plugged in a code reader yet?

If you have a voltmeter and the electrical guide in hand, we can help you to check likely problem areas.

Just...
05-19-2014, 07:11 AM
Replies: 5
Views: 2,153
Posted By AllanG

I don't know of one but am interested in why you...

I don't know of one but am interested in why you need the adjustment? Is it for a race setup?
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.