Jaguar Forums - Jaguar Enthusiasts Forum - Search Results

 
Search: Posts Made By: gkubrak
Showing results 1 to 25 of 185
Search took 0.05 seconds.
07-18-2019, 01:58 PM
Replies: 5
Views: 355
Posted By gkubrak

link...

link (https://www.sngbarratt.com/us/#!/English/FindParts/Families/XK/13/51/all/1/10/1/viewassembly/14920/:PROPSHAFT%20ASSEMBLY)
07-18-2019, 01:52 PM
Replies: 19
Views: 833
Posted By gkubrak

Does in only do this with the gear selector in...

Does in only do this with the gear selector in DRIVE?

Does it do this in SPORT mode? Does it do it when you try to use the paddle shifters?

What about reverse?
07-18-2019, 01:46 PM
Replies: 5
Views: 355
Posted By gkubrak

Looks like they don't sell the bearing...

Looks like they don't sell the bearing separately, just the whole propshaft assembly.

You should put your year and model so people know. Many parts don't carry over from the 07 - 09 models to the...
07-18-2019, 08:36 AM
Replies: 7
Views: 474
Posted By gkubrak

Its upside down! You ruined it!! Haha

Its upside down! You ruined it!! Haha
07-17-2019, 03:41 PM
Replies: 13
Views: 3,962
Posted By gkubrak

The code I was getting didn't mention a short to...

The code I was getting didn't mention a short to ground or a high resistance ground, so just by that logic, and good continuity I have to assume the ground is good.

I think the resistance is up...
07-17-2019, 12:28 PM
Replies: 53
Views: 4,077
Posted By gkubrak

Just to follow up on the issues ... P0193:...

Just to follow up on the issues ...

P0193: after doing pinpoint checks everything looked good. Seems the harness was getting pinched between coolant lines, causing an intermittent short....
07-16-2019, 02:23 PM
Replies: 6
Views: 411
Posted By gkubrak

Could have happened when I changed the pads and...

Could have happened when I changed the pads and rotors.

Maybe I should try to bleed them again.
07-16-2019, 12:15 PM
Replies: 6
Views: 411
Posted By gkubrak

The fluid was due to be changed, and they felt a...

The fluid was due to be changed, and they felt a bit spongy. No leaks noted around the abs pump or brake master cylinder.
07-16-2019, 11:51 AM
Replies: 6
Views: 411
Posted By gkubrak

Question on brake bleeding

Bled my brakes the other day and got a good amount of fluid out through both nipples on my Alcon calipers.

The rear left wheel had a significant amount of air come out to the point where I bled it...
07-16-2019, 09:40 AM
Replies: 13
Views: 3,962
Posted By gkubrak

Ok so I think I got it straightened out. Did...

Ok so I think I got it straightened out.

Did voltage tests and got 5V at both Input and VRef pins:...
07-12-2019, 12:35 PM
Replies: 1
Views: 478
Posted By gkubrak

I'm looking into this also. I replaced my sensor...

I'm looking into this also. I replaced my sensor due to a fuel leak (among other repairs I was doing at the time). Then the code started showing up. Someone was saying they replaced the fuel temp...
07-12-2019, 12:32 PM
Replies: 13
Views: 3,962
Posted By gkubrak

I'm trying to diagnose my P0193 code also. You're...

I'm trying to diagnose my P0193 code also. You're saying changing the Fuel Temp Sensor fixed this problem?

I don't see how that would work.
07-12-2019, 08:13 AM
Replies: 5
Views: 534
Posted By gkubrak

Thats a 07 - 09 XKR bumper. You can tell by the...

Thats a 07 - 09 XKR bumper. You can tell by the square fog light outline, and the lower grill outline.

It should fit 07 - 09 XK but won't fit 2010+ models due to different headlights.
07-10-2019, 09:57 PM
Replies: 5
Views: 930
Posted By gkubrak

I just removed and painted mine a few weeks ago....

I just removed and painted mine a few weeks ago. A can of black bumper paint from the auto store worked well.

Not sure if the 5.0 models are the same, but the 4.2 panel has 1 long 'clip' that runs...
07-10-2019, 04:23 PM
Replies: 54
Views: 11,832
Posted By gkubrak

Take Ranchero's advice above. I had this problem...

Take Ranchero's advice above. I had this problem a few days ago when I replaced my daytime lights with LEDs. Wires inside there were chafed beyond belief. Wish I had a pic.

Remove the headlamp...
07-10-2019, 12:19 PM
Replies: 24
Views: 1,951
Posted By gkubrak

I was gunna say they look legit, didn't look like...

I was gunna say they look legit, didn't look like they were from eBay.

Can you confirm no rubbing issues between tire and arch? I'm considering this mod too but want to make sure I don't have to...
07-09-2019, 12:24 PM
Replies: 105
Views: 10,889
Posted By gkubrak

So why did they put louvers on the XKR? You...

So why did they put louvers on the XKR?

You can also consider making a ram-air duct underneath the engine to relieve the hot spot by the firewall. Similar to the alternator cooling duct seen...
07-03-2019, 01:00 PM
Replies: 14
Views: 745
Posted By gkubrak

Both wheels were repaired and balanced by a wheel...

Both wheels were repaired and balanced by a wheel repair place and a tire place. Both reputable spots. If they haven't noticed anything then I can't keep forcing the issue. There aren't many places...
07-03-2019, 12:12 PM
Replies: 14
Views: 745
Posted By gkubrak

LOL you guys aren't hearing me ... see my post #4...

LOL you guys aren't hearing me ... see my post #4 above. Front wheels will not fit over alcon brakes in the back.

I have to find someone in the area with 20" rims who can let me borrow theirs.
07-03-2019, 07:15 AM
Replies: 14
Views: 745
Posted By gkubrak

Hahaa of course. All 4. How would I...

Hahaa of course. All 4.



How would I inspect/test the trans mount?

I have to rule out engine mounts because the vibrations do not vary by RPM. Also have to rule out transmission mount since...
07-02-2019, 12:39 PM
Replies: 14
Views: 745
Posted By gkubrak

Not sure how those could have been damaged in an...

Not sure how those could have been damaged in an impact but Ill check them out next time i'm underneath.
07-02-2019, 12:36 PM
Replies: 14
Views: 745
Posted By gkubrak

Can't. Front ones don't have the same offset and...

Can't. Front ones don't have the same offset and won't fit over the Alcon brakes. My idea was to find some1 in the area and borrow their wheels for an hour or so.

The wheels that were damaged from...
07-02-2019, 11:04 AM
Replies: 14
Views: 745
Posted By gkubrak

Need advice on highway vibration

Need some insight here...

Issue: steering wheel shimmy around 45 mph; steering wheel/foot pedal vibration and significant road noise around 50-80 mph; much worse when turning right on highway
...
06-29-2019, 03:33 PM
Replies: 12
Views: 1,197
Posted By gkubrak

Yeah i guess its different for NAs. Looks...

Yeah i guess its different for NAs.

Looks shorter too. Which makes sense if there is no intercooler in the way.
06-29-2019, 03:30 PM
Replies: 7
Views: 624
Posted By gkubrak

HAHA I love how the module says "achieve the...

HAHA I love how the module says "achieve the impossible".
Showing results 1 to 25 of 185
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.