When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hello, I am new to the site, so apologies if its the wrong area to post in.
I am in process of rebuilding a 2.0d Ingenium Engine, the Block has been rebored by 0.5mm to allow fitment of the new 83.5mm pistons / rings.
I can't seem to get the right compression on the expander Wavey Ring. Has anyone had this issue. The end cap on the rail is way to big and the expander is preventing compression. Any advise is much appreciated.
2 Piece Oil Ring Fitment
