I have a 8 way jag x250 seat that i want to use in my sim racing setup. I'm a complete noob on this subject I want to know how to power this what wires do I need to work with .also I have all the plugs on still

 

Dan,

Attached is the SEAT schematics from the X250 - Electrical Guide in PDF format.

As a newbie, you will not be able to download attachments from the forum so I'll send it to the eMail address you have registered with the forum. Look out for an eMail from jaguarforums@outlook.com with a large attachment. As you are unfamiliar with both Jaguars and electrics, it may raise as many questions as it answers.

Other members with this model should be able to advise on the details.

Graham

 

I've quoted your reply to my email here keep discussion within the thread.

That is the full section for the seats from the Electrical Guide which only includes 8 and 12 Way passenger side for LHD and RHD. Members with this model may know if there is an additional schematic available for the 8 and 12 Way driver side.

Graham

 

I found the 8 way section but I have the drivers side 8 way I would take a photo but the sites not allowing me to upload yet

 

Hi guys I used the wiring diagram on this page connected the four blacks and red/green ,red/blue ,red/white to a 12v 30 amp power supply ( )
now all the controls work externally I think the power supply needs more amps because I need to keep engaging the button to fully travel the seat but I'm more than happy cheers