Rear Diff Bolt
 

Speaking with my mechanics they are telling me that they have a 13 inch bolt that goes from the rear diff to the subframe that is seized. Anyone have a clue which bolt that they are speaking of. They are having a hard time rinding it. I assume that they are speaking ofMMB2860AA


Update - they are telling me it is Fulcrum Bolt CCC5455. Any help on this. I just got rid of my parts car.......damn
Update2...they are smoking something they are looking for
https://www.jaguarclassicparts.com/u...pper-and-lower
#14

How soon do you need it ?

Item # 2 , there is a donor car in KC

https://cimg5.ibsrv.net/gimg/www.jag...396d738312.png

That would be great but not sure if number two is the same as number 14 on the previous message. They did a work around by pulling everything and leaving the bolt but I willeventually need it,

Referencing thus link and let me know what you need and I will personally remove them without damage

The previous pic was for a X308 by mistake

https://www.jaguarclassicparts.com/u...hbone-assembly

Call this number around noon as the time I should arrive . If I haven't arrived leave an order and address

http://avenueautoparts.com/

The donor car was not wrecked so they should be straight

Sure I will take it if it is not too much trouble. Let me know what you want for it and shipping to Albuquerque NM and I will send it to you with Zelli or PayPal

I went to the car in the salvage yard today and the bolt about 17 inches long was laying in the car as remembered

The bolt is in good condition with perfect threads , not beaten or compressed

The bolt laying there is the length and diameter of the specific item # 2 going through the differential casting and the articulating arm ( # 1 wishbone )

The donor X300 has both # 2 ( left and right ) still installed with this one extra laying in the car but have already started to sell rear suspension pieces in the past

The question is the bolt ends as the assembled X300 looks to have different bolt ends and I'll have a better look at the ends again tomorrow

The priority time wise is to get the loose one to shipping and on it's way and charge purchase cost plus shipping only , that's the way I roll

Form of payment later as PM transaction but need shipping preference and address

The reason I did not grab the bolt was I was not !00 % sure that is what you needed and where did the loose one come from

Is there another bolt in the suspension you need ?

Do you need the nuts from the assembled donor car ?

I will look at mine more carefully and look at the front suspension on mine as the donor car has the fronts sold off in the past and wondering if that's where it came from

The pic of the solid Y wishbone of the X300 internet link is accurate when looking at it ( and available on both left and right sides of the donor car ) a open Y design of the pic on the above post is not what's present . I don't know where I came up with the pic

The left and right wishbones are different part #s