My engine swap is underway and last night we managed to get the engine out. In the process of removing a heater hose, I broke one of the nipples off where another hose connects. This is the main (I assume because it's the largest) hose with a big connector that you have to pry apart to disconnect. I'm looking to replace that plastic part that the hose connects to?

it broke where the smaller hose connects to the side of it. So I am guessing I will need the part of the hose that the "T" is on which is closer to the firewall:



you can see metal clamp holding the smaller hose onto the main one in the last pic.

 

I think this is piping...MNC6733AE...but just the connector of which I am unsure if sold separately. If you can get the name of the connector off it, you should be able to reference it.

 

I don't know what's going on, but I couldn't insert this into my previous? Anyways, here's the layout...

 

hello mr. horse
thanks for this schematic, but i dont think the connection that I broke is pictured here. I googled that part #. It is actually after the big plastic connector in the middle hose on this pic:

 

hmmm i think I found it



#9 in that pic part number
NNE3944BA



even found a pic of someone else who broke theirs lol:

 

Cool, as long as you can get it repaired without buying that whole assembly, that's a win.

 

Yeah you just replace that connector piece... That piece is not included on the huge octopus mess that was referenced previously