Group Buy: (4) Motorsport Tech hubcentric adapters/spacers
Have you guys been able to get ahold of Lenny? iv tried 8 different days and different times of the day (time zones are different so i figured i was just missing him), both numbers, no luck. and the mailbox is full. thanks - Josh
I'm honestly in no hurry since my car will not be leaving the garage any time soon so I have not been trying to contact him. This is our 3rd or 4th group buy with him and he runs a legitimate business so if there are concerns about whether this is actually happening, I would say you can put those concerns to rest. If its a timing thing, I would try emailing him if you keep missing him with the phone calls, he typically responds to my emails within a day. I can email him again, but like I said, I am confident he is working our group order and will get them out to us as soon as he can.
OK, gotcha...I didnt realize you were tracking him down to pay him. I will shoot him an email
***********************************
Im here at the office all day
Tell him to call the office at 775.351.1000
Lenny
***********************************
Got my confirmation today as well. FedEx doesn't have the delivery info yet but that's typical. I was never in a hurry, and also never worried.
EDIT: Now it's saying delivery tomorrow.
EDIT: Now it's saying delivery tomorrow.
Last edited by lizzardo; Feb 13, 2018 at 12:04 AM.
I've got mine in hand. Workmanship looks good; they're nicely machined and have 10.9 studs. Not sure when I'll get to installing them, but I'm not disappointed with what I've received.
Received my spacers today. not the highest quality measuring device, but pretty good show spacers at 17.15 mm thick! hope that is not a problem... they look nice though, will put them on next week. Will take before and after pictures.
Received mine today and installed the rears (ran out of time).
These do look like quality parts. As Vettegood said, these are a bit thicker, but only just... I mic'd mine at between 17.06-17.09mm, or <0.005". Should be fine.
I ended up cutting the studs down ~1/8" because the pocket in the wheels was only 1.5mm deeper than the height of the stud extension, and I was worried that variances could be more than that. I'll post photos later when all four are on.
These do look like quality parts. As Vettegood said, these are a bit thicker, but only just... I mic'd mine at between 17.06-17.09mm, or <0.005". Should be fine.
I ended up cutting the studs down ~1/8" because the pocket in the wheels was only 1.5mm deeper than the height of the stud extension, and I was worried that variances could be more than that. I'll post photos later when all four are on.







