pictures soon!
My head gasket was found to be in good condition however the #4 position is cracked and the cylinder is scaled with minor rust forcing me to re think my project. i am writing for suggestions because this is what im thinking i have no idea how to obtain it tho.
New rods and bearings oversized pistons with chrome rings and a cat claw head. supposedly the head will add 100 horse alone. any other ideas or information?

 

will a 3.4 head fit or no i have sent the old head out to be used as a template for intake and exhaust

 

You may want to magnaflux your block to make sure you don't have any cracks in it. Before spending a lot of time and money on the modifications make sure you have a good starting point. I'm guessing boring out the cylinder will clean up the scaling.

Good luck,

Mike

 

Ummmm... Conversion time maybe? I was looking on the price of rebuilding a Jag engine vs a conversion... ALOT cheaper with a conversion 90% less issues