When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am clearing out the garage attic and the following is going to the dumpster this week. Let me know of any interest, I will sell it for just about any offer plus shipping. Let me know asap- either reply here or send me a message. It will be gone soon.
Lots of other stuff too, but I will keep the smaller stuff a little longer.
I have listed part number where available. Body parts are red. Thanks!
rear bumper HJA6586BB
driver door
passenger door
RH fender & arch liner
intake manifold assy
driver door window GJA1001BG
passenger door window GJA1000BG
camshaft cover, pass NCA2562AB
camshaft cover, driver NCA2569AA
Wes, I think I do have that. Originally intended to keep it and try to sell the fender whole, but its been long enough.
Let me get out to the garage to confirm and I will get back to you.
Thanks!
Wes, here is the badge I have. It says "RH" on the back, and on the right (passenger in US) side it would leap towards the front.
Probably wrong side, unless you don't care which way it points!
Yes I do have the wood trim, and happy to sell it. There are some cracks in the shifter trim as shown below. The rest of it is good as I recall; I can put eyes on it before shipping to confirm.
The door switches do NOT come with it, one or both were already sold separately, but I do still have the switch trim surrounds.
PM me an offer, no reasonable offer refused, as they say!
It's a bit tough to see the condition of the pax air bag cover. And I see what you're saying about the shifter trim, so I don't think I'd need that. I hate to ask for better photos, but is that possible?
I'm moving, so will be throwing a bunch of stuff out. Once done, i will post updated list of what is available. I will be tossing large things like the doors and windows, and just keeping small stuff.
Wes, I think I do have that. Originally intended to keep it and try to sell the fender whole, but its been long enough.
Let me get out to the garage to confirm and I will get back to you.
Thanks!
Hey wondering if by chance you have the transmission cooler pipes?
Hello. Robert Grisar writing. Have a 2001 Jaguar XKR. Need the harness connector, male, for the heated oxygen sensor (HO2S). I have sensor, need harness side connector. Located between engine and firewall, center. Usually grey. About 1-1/2 x 1 x 1. Central connector, with pins, about 1/2 x 1/2. Can be cut on harness side to minimize time/labor. Thank you for looking. Very respectfully, Robert Grisar. email rgrisar <at> hot mail <dot> com.
Jaguar decal
