X-Type ( X400 ) 2001 - 2009
Sponsored by:
Sponsored by:

Houston Potholes taking their toll

Thread Tools
 
Search this Thread
 
Old Nov 21, 2017 | 01:20 PM
  #1  
Spikepaga's Avatar
Thread Starter
|
Veteran Member
Joined: Apr 2011
Posts: 2,991
Likes: 567
From: Houston, Texas
Default Houston Potholes taking their toll

my X type only has 55k miles but the pothole capital of the nation is starting to create problems for me. I can feel loose type noises up front developing.

What are the first components to go on a low mileage car like mine?
 
Reply
Old Nov 21, 2017 | 03:15 PM
  #2  
Dell Gailey's Avatar
Veteran Member
5 Year Member
Liked
Joined: Mar 2017
Posts: 4,769
Likes: 795
From: Utah
Default




I would hazard a wild guess as mine went. The front lower control arms, the ones with the fluid filled bushing towards the rear/firewall side. The Jaguar TSB on the "squeaking" fluid fail specifically mentions hot weather areas like Texas, Saudi Arabia, etc. As causing the bushing to fail. Mine not only squeaked, but rattled because of the bushings failing. It didn't mention Utah, but our 100+° summer (as compared to it's original home of New Jersey) killed them as well as the rear front lower arms. Bushings turned the crap. I also checked front and rear sway bar bushings, but as of this past weekend they are still fine. I replaced the links that hold the sway bar on both sides while I was at it. And I followed advice here to reverse the rear bolt holding the subframe so if this ever occurs again, I don't have to drop the subframe to change the parts.
 
Reply
Old Nov 21, 2017 | 03:40 PM
  #3  
Dell Gailey's Avatar
Veteran Member
5 Year Member
Liked
Joined: Mar 2017
Posts: 4,769
Likes: 795
From: Utah
Default



The reason I checked it all this last weekend. I had to bondo the hole I had to cut into the body of the car to access the large subframe bolt that the "captive nut" within the body was freely spinning. Not allowing the bolt to come out to drop the subframe.

Here's a picture of the arm bolt and why you have to drop the subframe to get it out = not enough clearance. So if you reverse the installation (nut on top, bolt through the bottom) you never have to drop the subframe again.

 
Reply

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -5. The time now is 06:33 PM.