i got the load resistors for my rear turn lamps today. I put the LED bulb in a few days ago and it looks great. the question ki have is what two wires do i conect the load resistors to? i can't figure it out. thanks

 

Perhaps this will give you an idea..

http://cgi.ebay.com/ebaymotors/LED-B...mZ150236985284

 

Vegas, remember also, if one wire initializes both the parking bulb and the 1st stage of the brake lamp, you will need two resistors in line on that one. I found that during my project.

 

i don't know if i need two. i installed them on the turn signals only. i found out the turn signal wires are the two wires closest to the outside of the car. I hooked one end of the resistor to that wire and the other wire i grounded to the car. it works!

 

adda boy - good job! If you get into the brake/tail lamps, you may have to remember the tip.

 

it was on the tail lamp. it only needed the one resistor per side.