I'm trying to buy a drill bit to be able to quickly remove and replace my rims with a set of winter wheels, and what size drill bit should I get?

 

I assume you mean socket and not drill bit lol

I use a 22mm socket on my lug nuts, I assume all XJ X308 lug nuts are the same. I must recommend a pneumatic impact gun and an air compressor or an electric impact gun. I have an ingersoll rand thundergun pneumatic impact gun and I can take my wheels on and off like a nascar pitcrew

 

LOL yea I meant socket!

 

Considering the cost of replacing those expensive little suckers due to appearance issues I loosen and tighten by hand and only use an air gun to spin off and on.

 

I use a 7/8 inch socket.

 

And always use a torque wrench to finish the job. Torque settings are 88-102Nm or 65-75lbf.t for alloys.

 

Agreed! The cost of these lug nuts is extremely high and hard to find! I have ugly open ended lug nuts from my VDP crown wheels installed on my asteriods. Has anyone seen lug nut caps that would fit these lug nuts to make them look better?