Series III V12 loose wiring ID needed
#1
Series III V12 loose wiring ID needed
Ahoy!
Thanks in advance for any help. I am just starting an engine bay tidy up after discovering some incorrectly connected vacuum lines and dodgy sensor wiring issues from the PO.
At the top edge of this pic, slightly to the left is a blue plug. What should this be connected to?
In this pic, you can see a tape wrapped connection just to the right of the oil filler cap. It comes from the same bundle as the intake temp and coolant temp sensors. Where should this one go?
Cheers
Bruce
Thanks in advance for any help. I am just starting an engine bay tidy up after discovering some incorrectly connected vacuum lines and dodgy sensor wiring issues from the PO.
At the top edge of this pic, slightly to the left is a blue plug. What should this be connected to?
In this pic, you can see a tape wrapped connection just to the right of the oil filler cap. It comes from the same bundle as the intake temp and coolant temp sensors. Where should this one go?
Cheers
Bruce
#2
#4
#5
The following users liked this post:
Grant Francis (11-16-2015)
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)