Jaguar Forums - Jaguar Enthusiasts Forum
0 2021/11/10 05:17:12
0 2021/11/08 13:53:05
speaker wire attached through a drilled hole to ECU connector
speaker wire attached through a drilled hole to ECU connector
0 2021/11/08 13:45:50
other side of plug going to injector harness
other side of plug going to injector harness
0 2021/10/24 07:18:32
Plug to Injector harness
Plug to Injector harness
0 2021/10/24 07:17:26
This is where I test Pin 7 The Y/W wire is cut`
This is where I test Pin 7 The Y/W wire is cut`
0 2021/10/19 13:11:22
0 2021/10/19 10:33:51
Drilled a hole on the connector casing and went directly to Pin 18
Drilled a hole on the connector casing and went directly to Pin 18
0 2021/10/19 10:27:40
my query is about this plug
my query is about this plug
0 2021/10/18 16:24:13
DVOM connected to cut Y/W wire going to the ECU
DVOM connected to cut Y/W wire going to the ECU
0 2021/10/14 11:41:59
Voltage reading from ECU on the cut Y/W wire
Voltage reading from ECU on the cut Y/W wire
0 2021/10/14 11:37:50
With the Y/W wire complete I still had the voltage shown.
With the Y/W wire complete I still had the voltage shown.
0 2021/10/14 11:35:08
0 2021/10/14 09:48:51
Test light lead connected to ground. Test light tip touching the "DWW" connector.
Test light lead connected to ground. Test light tip touching the "DWW" connector.
0 2021/10/13 05:17:15
other side of connector to injector harness
other side of connector to injector harness
0 2021/10/13 05:12:39
connector to injector harness
connector to injector harness
0 2021/10/13 05:11:27
0 2021/10/08 09:25:36
Not clear. but the reading drops to 8v at the - side of coil and dreaded wire plug coming from the amp when cranking the engine. Needle does not move during cranking mode
Not clear. but the reading drops to 8v at the - side of coil and dreaded wire plug coming from the amp when cranking the engine. Needle does not move during cranking mode
0 2021/10/07 12:23:29
KEY ON: meter connected to the - side of coil,
KEY ON: meter connected to the - side of coil,
0 2021/10/07 12:19:51
0 2021/10/06 05:51:32
Engine almost completed
Engine almost completed
0 2021/10/04 13:44:07
0 2021/09/28 03:02:43
0 2021/09/28 03:01:59
to this. so far.
to this. so far.
0 2021/09/24 03:48:29
from this
from this
0 2021/09/24 03:47:01
another view
another view
0 2021/09/24 03:38:13
View of Lseat leather covers
View of Lseat leather covers
0 2021/09/24 03:36:58
I threaded a screw in the pipe a used lead solder to seal it. The pipe extension will receive an O-ring
I threaded a screw in the pipe a used lead solder to seal it. The pipe extension will receive an O-ring
0 2021/09/22 13:02:40
new harness with plugs
new harness with plugs
0 2021/09/21 16:23:09
Rear Scuttle
Rear Scuttle
0 2021/09/19 14:16:46
Installed my seats and Center Console
Installed my seats and Center Console
0 2021/09/19 14:15:44
tools of the trade. Rather than use the commercial stuff. I thought that if DAWN removes baked on grease, it should work on the engine.
tools of the trade. Rather than use the commercial stuff. I thought that if DAWN removes baked on grease, it should work on the engine.
0 2021/09/15 11:58:42
to this
to this
0 2021/09/15 11:57:47
from this
from this
0 2021/09/15 11:57:01
painted by me 4 years ago
painted by me 4 years ago
0 2021/09/12 14:46:37
Painted by me last year
Painted by me last year
0 2021/09/12 14:45:40
0 2021/09/12 14:44:52
LSeat leather seat covers installed by me. Not happy. Sent it to the upholsterer to put new seat foam.
LSeat leather seat covers installed by me. Not happy. Sent it to the upholsterer to put new seat foam.
0 2021/09/12 13:21:19
LT1 and 4L60E installed
LT1 and 4L60E installed
0 2021/09/12 13:20:13
Engine bay cleaned and repainted
Engine bay cleaned and repainted
0 2021/09/12 13:19:12