Jaguar Forums - Jaguar Enthusiasts Forum
0 2022/08/14 05:34:40
0 2022/08/14 05:34:34
Remove small partial raised ring from around the tweeter case
Remove small partial raised ring from around the tweeter case
0 2022/08/14 05:34:25
On arm of speaker brace could vibrate here so need treatment
On arm of speaker brace could vibrate here so need treatment
0 2022/08/14 05:34:21
Remove raised ring form back of speaker baffle for tweeter
Remove raised ring form back of speaker baffle for tweeter
0 2022/08/14 05:34:16
You will need to remove both the speaker baffle and the speakers and brace form the car
You will need to remove both the speaker baffle and the speakers and brace form the car
0 2022/08/14 05:34:10
0 2022/08/11 20:53:52
0 2022/08/11 20:53:45
0 2022/08/11 20:53:35
Original wiring is long enough without need to splice in any extension wiring. Seat is at maximum tilt and forward position so no chance to over tensioning the wire
Original wiring is long enough without need to splice in any extension wiring. Seat is at maximum tilt and forward position so no chance to over tensioning the wire
0 2022/08/05 23:55:47
0 2022/08/05 23:55:40
0 2022/08/05 23:55:34
Screwed into the back with 1cm long screws. Will leave 4 small holes if removed in the plastic backing but no one will ever see that area in reality unless you take your seats out of the car. Unit can also be tucked under the plastic seat backing without screwing but then quite low which is still fine.
Screwed into the back with 1cm long screws. Will leave 4 small holes if removed in the plastic backing but no one will ever see that area in reality unless you take your seats out of the car. Unit can also be tucked under the plastic seat backing without screwing but then quite low which is still fine.
0 2022/08/05 23:55:26
Posi taps to one of the channels. Yellow is negative
Posi taps to one of the channels. Yellow is negative
0 2022/08/05 23:55:16
0 2022/07/01 21:18:06
Need to remove blue and red wire. One for each coil of DVC subwoofer
Need to remove blue and red wire. One for each coil of DVC subwoofer
0 2022/07/01 21:17:57
Release the pins by gently without breaking levering the grey locking tab downwards and wiggle pin out backwards
Release the pins by gently without breaking levering the grey locking tab downwards and wiggle pin out backwards
0 2022/07/01 21:17:47
Easily done by releasing and pushing forward on the side tabs that hold it in place
Easily done by releasing and pushing forward on the side tabs that hold it in place
0 2022/07/01 21:17:40
The white plastic inser needs to be removed first. Don’t forget to put it back in later
The white plastic inser needs to be removed first. Don’t forget to put it back in later
0 2022/07/01 21:17:32
There are small grey plastic tabs that are part of the connector that have to be gentle released before you can pull out the pins. You need to remove the ones shown , one for each voice coil of the subwoofer.
There are small grey plastic tabs that are part of the connector that have to be gentle released before you can pull out the pins. You need to remove the ones shown , one for each voice coil of the subwoofer.
0 2022/07/01 21:10:51
Release by pushing forward the locking tabs on both side and remove white plastic bit completely. Remember to reinstall later
Release by pushing forward the locking tabs on both side and remove white plastic bit completely. Remember to reinstall later
0 2022/07/01 21:10:45
The white plastic pin lock needs to be removed form the connector first
The white plastic pin lock needs to be removed form the connector first
0 2022/07/01 21:10:30
0 2022/06/26 06:19:09
0 2022/05/12 23:29:43
This is the seller Shop name
This is the seller Shop name
0 2022/05/12 23:29:32
0 2022/05/12 23:25:20
0 2022/05/12 23:25:12
0 2022/05/12 23:25:05
0 2022/05/12 23:24:58
0 2022/05/12 23:24:49
0 2022/01/29 15:25:47
With LEDs
With LEDs
0 2022/01/19 01:58:17
0 2022/01/19 01:58:09
0 2022/01/19 01:58:01
Made a trim ring as well
Made a trim ring as well
0 2022/01/19 01:57:52
Finally finished my install
Finally finished my install
0 2022/01/19 01:57:44
Since no one has answered yet …….Just pull forward from the top. Just non breakable clips here where the arrows are. Once top is loose just lift the entire panel upwards as sits on some vertically oriented pins at the base.
Since no one has answered yet …….Just pull forward from the top. Just non breakable clips here where the arrows are. Once top is loose just lift the entire panel upwards as sits on some vertically oriented pins at the base.
0 2022/01/01 21:32:01
This side has an even bigger gap.
This side has an even bigger gap.
0 2021/10/30 17:07:22
Water will drain off roof to this area. This side has a small gap between the seal and the body work
Water will drain off roof to this area. This side has a small gap between the seal and the body work
0 2021/10/30 17:07:18
0 2021/05/28 07:01:44