Jaguar Forums - Jaguar Enthusiasts Forum
et voila. I managed to get a replacement bonnet for 90GBP but if you want to repair the damaged bonnet you could. Remove the old, hacked catch assembly (two screws) then fibreglass a patch to the inside of the top edge. source and fit a new catch assembly.
et voila. I managed to get a replacement bonnet for 90GBP but if you want to repair the damaged bonnet you could. Remove the old, hacked catch assembly (two screws) then fibreglass a patch to the inside of the top edge. source and fit a new catch assembly.
0 2021/09/21 11:29:07
I made a template by tracing round the "retaining catch assembly" on the replacement bonnet then carefully hacked out the appropriate section of the upper skin.
I made a template by tracing round the "retaining catch assembly" on the replacement bonnet then carefully hacked out the appropriate section of the upper skin.
0 2021/09/21 11:29:14
this is the resultant hole
this is the resultant hole
0 2021/09/21 11:29:21
in close-up you can see the back side of the "retaining catch assembly". if you can cut within the outer retaining studs you will be able to replace the assembly with a replacement
in close-up you can see the back side of the "retaining catch assembly". if you can cut within the outer retaining studs you will be able to replace the assembly with a replacement
0 2021/09/21 11:29:26
I needed to open up the hole in the outer skin to get my tool in to cut the latch free
I needed to open up the hole in the outer skin to get my tool in to cut the latch free
0 2021/09/21 11:29:32
The retaining catch is now free from the bonnet
The retaining catch is now free from the bonnet
0 2021/09/21 11:29:36
0 2021/09/25 09:44:22
0 2021/09/25 09:44:27
0 2021/09/25 09:44:33
0 2021/09/25 09:44:40
0 2021/09/25 09:46:09
0 2021/09/25 09:46:13
0 2021/09/25 09:46:21
0 2021/09/25 09:46:26
This is the back of the connector that is screwed to the diecast box. Seems to have only three connections., the middle one disintegrated as I withdrew the connector from the box
This is the back of the connector that is screwed to the diecast box. Seems to have only three connections., the middle one disintegrated as I withdrew the connector from the box
0 2021/09/25 09:55:55
Oxide everywhere. The O ring wasn't in the seat
Oxide everywhere. The O ring wasn't in the seat
0 2021/09/25 09:56:01
0 2021/09/25 09:56:05
This is the fron of the radar box mounted connector. the leftmost of 5 pins is stuck in the wiring harness
This is the fron of the radar box mounted connector. the leftmost of 5 pins is stuck in the wiring harness
0 2021/09/25 09:56:12
0 2021/09/25 13:35:15
0 2021/09/26 03:02:02
0 2021/09/26 03:03:41