Jaguar Forums - Jaguar Enthusiasts Forum
0 2025/11/22 03:38:13
0 2021/02/14 13:39:55
0 2021/02/14 13:39:50
0 2021/02/14 13:39:43
0 2021/02/09 14:05:29
0 2021/02/09 14:05:19
Front end well filled out.
Front end well filled out.
0 2020/10/08 18:35:59
Fully installed and ready for bleeding
Fully installed and ready for bleeding
0 2020/10/04 02:10:15
5mm spacer installed. This is actually 2 each 3mm’s stacked done just to determine Ned spacing. Final install was done with single H&R spacer.
5mm spacer installed. This is actually 2 each 3mm’s stacked done just to determine Ned spacing. Final install was done with single H&R spacer.
0 2020/10/04 02:07:05
Smaller dust shield on top of larger svr shield showing where to notch back svr shield or else large caliper will interfere.
Smaller dust shield on top of larger svr shield showing where to notch back svr shield or else large caliper will interfere.
0 2020/10/04 02:04:07
Wheel installed with 15mm spacer
Wheel installed with 15mm spacer
0 2020/09/05 18:31:04
Svr rotor and disk installed
Svr rotor and disk installed
0 2020/09/05 18:29:42
Ecu label serial number third row down. Look for FR at the end.
Ecu label serial number third row down. Look for FR at the end.
0 2020/03/22 05:28:39
Serial number label under large wire loom
Serial number label under large wire loom
0 2020/03/22 05:28:32
Open cover
Open cover
0 2020/03/22 05:28:24
Blue tape marks the ecu cover
Blue tape marks the ecu cover
0 2020/03/22 05:26:45
Lower aero duct guide installed
Lower aero duct guide installed
0 2019/09/01 17:32:18
Griil inserted prior to remounting bumper
Griil inserted prior to remounting bumper
0 2019/09/01 17:32:14
Bumper removed
Bumper removed
0 2019/09/01 17:32:10
Before
Before
0 2019/09/01 17:32:06
Bumper re-instalked
Bumper re-instalked
0 2019/09/01 17:32:02
Done!
Done!
0 2019/09/01 17:31:57
0 2019/08/26 17:29:51
0 2019/08/26 17:29:47
0 2019/08/26 17:27:00
0 2019/08/26 17:26:56
Carbon fiber grill surround and lower duct guides added
Carbon fiber grill surround and lower duct guides added
0 2019/08/26 17:24:21
0 2019/03/30 14:47:17
Needed a third hand so I put a jack handle on my ratchet used to release the belt tensioner. Hooked a ratchet strap to the jack handle and tied the strap off on the family lawn mower! American ingenuity. Or redneck engineering??
Needed a third hand so I put a jack handle on my ratchet used to release the belt tensioner. Hooked a ratchet strap to the jack handle and tied the strap off on the family lawn mower! American ingenuity. Or redneck engineering??
0 2019/03/30 14:47:09
0 2019/03/28 08:09:37
0 2019/03/28 08:09:24
0 2019/03/28 08:09:08
0 2019/03/28 08:02:09
0 2019/03/28 07:58:59
0 2019/03/28 07:57:52
0 2019/03/17 11:23:52
0 2019/03/17 11:23:11
0 2019/03/17 11:22:50
0 2019/03/06 16:22:05
0 2019/03/01 10:54:18