Jaguar Forums - Jaguar Enthusiasts Forum
0 2026/04/16 00:58:27
Cams.. measured all lobe lifts..
Cams.. measured all lobe lifts..
0 2026/03/16 00:52:05
New water pump, front end open (what a struggle to get the steering pump bracket out of the way)
New water pump, front end open (what a struggle to get the steering pump bracket out of the way)
0 2026/03/16 00:52:03
LH side awaiting for its turn.
LH side awaiting for its turn.
0 2026/03/16 00:52:01
Measuring all tappet shim. (the little suction cup to pull the buckets out, speaker magnet to pull the shim off bucket)
Measuring all tappet shim. (the little suction cup to pull the buckets out, speaker magnet to pull the shim off bucket)
0 2026/03/16 00:51:59
0 2025/09/25 00:37:53
0 2025/09/25 00:37:50
0 2025/09/25 00:37:48
0 2025/09/23 02:17:00
My new shiny aluminum thermostat housing.
My new shiny aluminum thermostat housing.
0 2025/08/24 23:59:55
A neat setup, using a small car battert and a cheap electric ”oilchanger pump” sucking from bottle and filling gearbox without making a total mess.. It took 3liters to get to full again.
A neat setup, using a small car battert and a cheap electric ”oilchanger pump” sucking from bottle and filling gearbox without making a total mess.. It took 3liters to get to full again.
0 2025/06/01 23:58:02
Nice and clean.
Nice and clean.
0 2025/06/01 23:55:13
0 2025/05/18 13:17:37
0 2025/05/18 13:17:32
0 2025/05/06 01:19:04
Here you see the top of the l/h catalytic converter, the plastic tube between MAF sensor and inlet housing removed for axccess.. oxy sensor on its way out.. The nuts holding the cat to the exhaust manifold are, when they are new, pinched a bit i norder to not back of and become loose.. Be aware, they tend to cut in to the threads when backed off..
Here you see the top of the l/h catalytic converter, the plastic tube between MAF sensor and inlet housing removed for axccess.. oxy sensor on its way out.. The nuts holding the cat to the exhaust manifold are, when they are new, pinched a bit i norder to not back of and become loose.. Be aware, they tend to cut in to the threads when backed off..
0 2017/10/03 15:52:08
My "new" cat, cleaned up and a layer of high temp paint..
My "new" cat, cleaned up and a layer of high temp paint..
0 2017/10/03 15:50:58
This is what a good cheramic core should look like.. nice and clean, not burned trough anywhere or full of soot..
This is what a good cheramic core should look like.. nice and clean, not burned trough anywhere or full of soot..
0 2017/10/03 15:49:32
This is what i saw when taking a peek inside the old cat.. empty.. its not the core you see.. its the bottom of the cat where i put my flashlight..
This is what i saw when taking a peek inside the old cat.. empty.. its not the core you see.. its the bottom of the cat where i put my flashlight..
0 2017/10/03 15:47:54
The crash kill switch sits on the torpedo, far left with a rubber tit on top.. -press it. (trim panel removed on this pic though)
The crash kill switch sits on the torpedo, far left with a rubber tit on top.. -press it. (trim panel removed on this pic though)
0 2017/10/03 07:52:54
I used a decent, fairly sized, hand cranked tool with replaceble heads. Found it on ebay, not especially expensive..
I used a decent, fairly sized, hand cranked tool with replaceble heads. Found it on ebay, not especially expensive..
0 2017/10/03 00:35:57
Make sure your rear whee lbearings still are well greased... else.. regerase or maybe replace them as well....
Make sure your rear whee lbearings still are well greased... else.. regerase or maybe replace them as well....
0 2017/10/03 00:34:08
--while your at it, make sure your lower arm bearings in the hub are in good condition too..
--while your at it, make sure your lower arm bearings in the hub are in good condition too..
0 2017/10/03 00:33:18
While your at it, make sure your lower arm roller bearings are ok...
While your at it, make sure your lower arm roller bearings are ok...
0 2017/10/03 00:30:51
A decent handcranked spring compressor, found on ebay. Not especially expensive.
A decent handcranked spring compressor, found on ebay. Not especially expensive.
0 2017/10/03 00:29:39
A decent handcranked spring compressor with removable "heads" found on ebay. Not especially expensive.
A decent handcranked spring compressor with removable "heads" found on ebay. Not especially expensive.
0 2017/10/03 00:26:46
Pooking on this plug caused the car to die..
Pooking on this plug caused the car to die..
0 2017/07/03 04:39:54
Loose wire... the plugs are not fitted in there respective positions and are dangeling around..
Loose wire... the plugs are not fitted in there respective positions and are dangeling around..
0 2017/07/03 04:38:56
It was quite a challenge to get the pin out from the plug...
It was quite a challenge to get the pin out from the plug...
0 2017/07/03 04:36:34
Door in pieces, glass out..
Door in pieces, glass out..
0 2017/05/21 23:50:51
Well.. a picture says more than...
Well.. a picture says more than...
0 2017/05/21 23:49:50
The lifting motor/mechanism
The lifting motor/mechanism
0 2017/05/21 23:49:20
Spring compressor.. not expensive and a very useful tool..
Spring compressor.. not expensive and a very useful tool..
0 2017/05/17 22:52:15
.. the reason my rear suspension was squeking..
.. the reason my rear suspension was squeking..
0 2017/05/17 22:50:29
Bits and pieces.. had no hydraulic press so i carefully klubbed everything out..
Bits and pieces.. had no hydraulic press so i carefully klubbed everything out..
0 2017/05/16 00:06:58
Discolouration and rollers not round any more..
Discolouration and rollers not round any more..
0 2017/05/16 00:06:01
He borrowed his dads Toyota.. il bet he got grounded..
He borrowed his dads Toyota.. il bet he got grounded..
0 2017/05/09 00:28:21
Japaneese chickenshit...
Japaneese chickenshit...
0 2017/05/09 00:25:30
The Toyota more or less fragmented itself.. The Jaguar is still beautiful and charming.
The Toyota more or less fragmented itself.. The Jaguar is still beautiful and charming.
0 2017/05/09 00:22:51