Jaguar Forums - Jaguar Enthusiasts Forum
P1010127
P1010127
2 2012/11/29 09:55:17
Footwell in, welds flushed and coat of overseal
Footwell in, welds flushed and coat of overseal
1 2013/01/14 12:42:47
brown stuff = rust being removed
brown stuff = rust being removed
1 2013/01/05 17:01:39
Footwell
Footwell
0 2013/01/14 12:42:47
Sill with primer
Sill with primer
0 2013/01/14 12:42:47
Sill panel in, welds flushed off...
Sill panel in, welds flushed off...
0 2013/01/14 12:36:19
closing panel left to fit, end length to trim when wing is back on
closing panel left to fit, end length to trim when wing is back on
0 2013/01/14 12:36:19
end panel needed now
end panel needed now
0 2013/01/14 12:36:19
WP 000199
WP 000199
0 2013/01/09 13:27:11
WP 000200
WP 000200
0 2013/01/09 13:27:11
WP 000201
WP 000201
0 2013/01/09 13:27:11
wishbone half de-rusted
wishbone half de-rusted
0 2013/01/05 17:01:39
wishbone half de-rusted...
wishbone half de-rusted...
0 2013/01/05 16:58:25
R/H inner wing repair over chassis box section already replaced.
R/H inner wing repair over chassis box section already replaced.
0 2013/01/05 16:58:25
R/H footwell replacement started
R/H footwell replacement started
0 2013/01/05 16:58:25
grind flush and prime
grind flush and prime
0 2013/01/05 16:55:30
final chassis repair plate ready for fitting
final chassis repair plate ready for fitting
0 2013/01/05 16:55:30
Got there eventually
Got there eventually
0 2012/12/31 13:23:43
Ye Olde Mig Welder....going to be pressed back into use shortly....hopefully won't need that red tool on top....
Ye Olde Mig Welder....going to be pressed back into use shortly....hopefully won't need that red tool on top....
0 2012/12/31 13:23:43
Tok some sweat to get to this!
Tok some sweat to get to this!
0 2012/12/31 13:21:39
So I don't forget....how to rebuild it!
So I don't forget....how to rebuild it!
0 2012/12/31 13:21:39
Wishbone in the bath, goodbye rust!
Wishbone in the bath, goodbye rust!
0 2012/12/31 13:21:39
2 amps showing....4 amps ideal for best results....
2 amps showing....4 amps ideal for best results....
0 2012/12/31 13:19:24
Electrolysis bath...magic does happen!
Electrolysis bath...magic does happen!
0 2012/12/31 13:19:24
dificult to see the bubbles from this pic, but it is all good - rust coming off!
dificult to see the bubbles from this pic, but it is all good - rust coming off!
0 2012/12/31 13:19:24
R/H Chassis at V-mount
R/H Chassis at V-mount
0 2012/12/30 11:35:21
R/H chassis at V-mount position from below with rot cut out
R/H chassis at V-mount position from below with rot cut out
0 2012/12/30 11:35:21
R/H footwell after a bit of cutting...
R/H footwell after a bit of cutting...
0 2012/12/30 11:35:21
R/H sill....started as a bit of a bubble....
R/H sill....started as a bit of a bubble....
0 2012/12/30 11:32:49
L/H sill a bit worse than expected...
L/H sill a bit worse than expected...
0 2012/12/30 11:32:49
Top tip.....do not cut through cable loom with cutting disc :-0
Top tip.....do not cut through cable loom with cutting disc :-0
0 2012/12/30 11:32:49
Special Jaguar engine support tool.....
Special Jaguar engine support tool.....
0 2012/12/29 14:42:09
Big hole!
Big hole!
0 2012/12/29 14:42:09
R/H side
R/H side
0 2012/12/29 14:42:09
R/H side from below
R/H side from below
0 2012/12/29 14:36:14
Assume this is spark erosion....
Assume this is spark erosion....
0 2012/12/29 14:36:14
Hole with some bare metal
Hole with some bare metal
0 2012/12/29 14:36:14
side on L/H
side on L/H
0 2012/12/29 14:34:15
underneath chassis L/H
underneath chassis L/H
0 2012/12/29 14:34:15
Big hole.....
Big hole.....
0 2012/12/29 14:34:15