Jaguar Forums - Jaguar Enthusiasts Forum
This is the piston out of the block and the retraining ring above. The front black oring I am going to replace. This is the one that has failed causing the seepage. The rear ring is the one that moves the piston in and out.
This is the piston out of the block and the retraining ring above. The front black oring I am going to replace. This is the one that has failed causing the seepage. The rear ring is the one that moves the piston in and out.
0 2021/04/26 18:50:27
Here I used a small allen wrench and pushed in the hole. Then I was able to use a pic to remove the ring.
Here I used a small allen wrench and pushed in the hole. Then I was able to use a pic to remove the ring.
0 2021/04/26 18:48:13
The hole is actually used to help push the retraining ring up so it can be removed
The hole is actually used to help push the retraining ring up so it can be removed
0 2021/04/26 18:46:11
This is the cylinder out of the car. I saw the little jole in the cylinder block and thought I must have an keeper screw to hold the piston in the block.
This is the cylinder out of the car. I saw the little jole in the cylinder block and thought I must have an keeper screw to hold the piston in the block.
0 2021/04/26 18:42:48
0 2021/04/25 15:25:41
0 2021/04/25 15:24:13
0 2021/04/24 07:56:27
0 2021/04/24 07:52:44
0 2021/04/22 13:06:17
0 2021/04/22 13:05:03
0 2021/04/20 16:11:56
0 2021/04/20 16:10:51
0 2021/04/20 16:02:56
0 2021/04/20 16:00:45
0 2021/04/20 15:58:55
This is the part you will more than likely need. Quite often the black plastic piece that locks the tube in will break, from being over 20 years old and the heat cycles. If it does break you will only need to replace the black plastic piece.
This is the part you will more than likely need. Quite often the black plastic piece that locks the tube in will break, from being over 20 years old and the heat cycles. If it does break you will only need to replace the black plastic piece.
0 2021/03/27 07:21:48
This the plastic tube. The left side goes into the fitting.
This the plastic tube. The left side goes into the fitting.
0 2021/03/27 07:18:56
This is where it is connected under the throttle boby.
This is where it is connected under the throttle boby.
0 2021/03/27 07:16:14
0 2021/03/27 07:13:42
0 2021/02/27 06:54:40
The inner guide failed
The inner guide failed
0 2021/02/24 02:48:03
0 2021/02/24 02:47:57
0 2021/02/24 02:47:52
0 2021/02/13 13:05:43
0 2021/02/13 13:05:28
2000 XK8
2000 XK8
0 2021/02/13 11:12:12
0 2020/02/16 07:44:18
0 2020/02/16 07:43:26
0 2019/09/06 06:22:21
0 2019/09/06 06:22:11
0 2019/09/06 06:16:59
This shows the table with the combo on it . To the right is the engine that is going into the car. In the background is what my wife calls crap.
This shows the table with the combo on it . To the right is the engine that is going into the car. In the background is what my wife calls crap.
0 2019/09/02 09:00:31
0 2019/09/02 07:24:52
0 2019/09/02 07:23:48
0 2019/08/18 19:46:20
0 2019/08/18 19:45:23
Remove the steering column from the rack. I had to remove the lower shaft from under the dash and was then able to push that section into the cabin enough for the exhaust manifold to clear.
Remove the steering column from the rack. I had to remove the lower shaft from under the dash and was then able to push that section into the cabin enough for the exhaust manifold to clear.
0 2019/08/18 18:28:20
0 2019/08/18 18:27:17
0 2019/08/18 18:26:48
Unplug the transmission harness and remove the linkage
Unplug the transmission harness and remove the linkage
0 2019/08/18 18:25:16