Jaguar Forums - Jaguar Enthusiasts Forum
0 2020/06/10 13:31:48
0 2020/06/09 17:56:36
0 2020/06/09 17:56:26
0 2020/06/09 17:56:17
0 2020/05/27 13:36:43
New units installed!
New units installed!
0 2020/05/16 05:26:24
Spring is assembled on to the shock, but now it’s impossible to remove the clamps!
Spring is assembled on to the shock, but now it’s impossible to remove the clamps!
0 2020/05/16 05:21:21
The strut compression tool I borrowed. Note the shock is not included so I could better show the large clamps
The strut compression tool I borrowed. Note the shock is not included so I could better show the large clamps
0 2020/05/16 05:20:59
Old unit to the left and new shock and spring to the right.
Old unit to the left and new shock and spring to the right.
0 2020/05/16 05:20:38
The spring is captured by the shock, so no worries of a sudden release of energy when you pull the unit off of the car.
The spring is captured by the shock, so no worries of a sudden release of energy when you pull the unit off of the car.
0 2020/05/16 05:14:40
Mine were corroded in place and I almost stripped one of the nuts trying to get it off.
Mine were corroded in place and I almost stripped one of the nuts trying to get it off.
0 2020/05/16 05:11:04
0 2020/05/16 05:01:54
Nut outside the cage at rear
Nut outside the cage at rear
0 2020/05/16 05:01:49
Bolt ends inside the cage
Bolt ends inside the cage
0 2020/05/16 05:01:42
0 2020/05/16 04:59:18
0 2020/05/16 04:59:04
Bottom of shock free after removing pin
Bottom of shock free after removing pin
0 2020/05/16 04:52:17
0 2020/05/16 04:47:18
The hub only needs to go up a fraction of an inch to take the weight off the pin
The hub only needs to go up a fraction of an inch to take the weight off the pin
0 2020/05/16 04:47:02
And a thicker spacer at the front between the shock and suspension arm. The washer next to the nut stays in place when you remove the pin.
And a thicker spacer at the front between the shock and suspension arm. The washer next to the nut stays in place when you remove the pin.
0 2020/05/16 04:41:57
There was a thin washer between the shock and bracket at the rear. (Note: pliers not needed to remove, just using these so my fat sausage fingers don’t obscure the view!)
There was a thin washer between the shock and bracket at the rear. (Note: pliers not needed to remove, just using these so my fat sausage fingers don’t obscure the view!)
0 2020/05/16 04:41:50
Pin location towards rear of car
Pin location towards rear of car
0 2020/05/16 04:35:30
Pin location towards front of car
Pin location towards front of car
0 2020/05/16 04:35:23
Which way should I orient the half moon pieces?
Which way should I orient the half moon pieces?
0 2020/05/13 13:18:46
0 2020/05/12 13:38:17
The original factory speaker
The original factory speaker
0 2020/05/12 13:37:46
0 2020/05/09 12:22:47
Followed by washer fluid
Followed by washer fluid
0 2020/05/09 10:39:13
The old fluid that was spit out
The old fluid that was spit out
0 2020/05/09 10:39:09
0 2020/05/09 10:37:48
0 2020/05/03 10:38:11
This one?
This one?
0 2020/05/02 08:11:23
0 2020/04/30 11:54:45
And this one is corroded, to boot!
And this one is corroded, to boot!
0 2020/04/30 11:54:27
0 2020/04/28 15:52:33
0 2020/04/28 15:51:55
0 2020/04/27 08:47:12
Next step (these are the old calipers BTW)
Next step (these are the old calipers BTW)
0 2020/04/27 05:25:53
0 2020/04/20 17:37:04
0 2020/04/20 17:36:04