I had my radiator rebuilt and after I installed it I noticed that it's loose on the top. Did I miss something. There are no mounting bolts.

 

There should be two huge rubber bungs that push-fit into the radtop panel, the holes in the middle of which go over the two prongs sticking up from the radiator. maybe these are missing?
Number 11 in this diagram. Two at the bottom and two at the top

 

Hi BC

You can see one of the Rubber Bungs in this Photo, which fit into holes in the Top Closing Panel, that go over the Top Pegs on the Rad to hold it in place. (Just like Greg said)


On the Top Closing Panel is a Rubber Bung each end that go over the pegs in the Top of the Rad to hold it in place

 

Thank you for the quick response. My rad is missing those. Probably because mine has a sbc. I'll have to figure something out