Gearbox Fault 04 xtype 3.0
#1
Gearbox Fault 04 xtype 3.0
Hey guys,
My check engine light is on, reading a code P1000. I've read about the drive cycle not being complete, or something along those lines. When I hook it up to the computer, a light comes on "Gearbox Fault." I've seen this light before but it just goes away, along with "cruise not available." I've read something about it going into LIMP mode, or safe mode(?). The car drives fine. I had my transmission serviced last year, in May I believe, and everything was fine. The most I have driven my car is roughly the 15 minute commute to work. The ABS light is on, the gearbox fault light only comes on when I hook it up to the computer, and the check engine light is on reading code P1000. The car drives fine. I took a look at the TCM and it looked good. Can anyone point me into a direction where I can have this resolved?
My check engine light is on, reading a code P1000. I've read about the drive cycle not being complete, or something along those lines. When I hook it up to the computer, a light comes on "Gearbox Fault." I've seen this light before but it just goes away, along with "cruise not available." I've read something about it going into LIMP mode, or safe mode(?). The car drives fine. I had my transmission serviced last year, in May I believe, and everything was fine. The most I have driven my car is roughly the 15 minute commute to work. The ABS light is on, the gearbox fault light only comes on when I hook it up to the computer, and the check engine light is on reading code P1000. The car drives fine. I took a look at the TCM and it looked good. Can anyone point me into a direction where I can have this resolved?
Last edited by Jtravis22; 07-21-2014 at 06:41 PM. Reason: shortening
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)