Headliner
All, I have a 2002, 3.0, gas, AT. Looking for source/recommendations for a replacement headliner (Sand-ADX).
local auto upholstery shops are quoting between $600-$800 to re-fabric the headliner. One shop said it’s SUPER difficult to remove headliner, “have to remove the rear glass”. Bypassing that shop for sure. Thanks in advance
local auto upholstery shops are quoting between $600-$800 to re-fabric the headliner. One shop said it’s SUPER difficult to remove headliner, “have to remove the rear glass”. Bypassing that shop for sure. Thanks in advance
RBaczek, I pulled the headliner myself, took it to a shop and for around $200, they put new fabric on it. Sure it took me 6 hours to remove and install, but that was a lot of money saved in labor. The headliner can be removed out the rear doors, just have to C the headliner around the front seats as you lay them all the way back.
Not a problem to remove if you have an estate 
Do need to be careful around the pillars when removing the side airbags.
When you go to reinstall, I recommend you install new and thicker insulation in the roof as well. I believe the heat transference from the sun hitting the roof is the primary cause for glue failure on the headliner. The rooftops could have stood to have better/more insulation to reduce the heat transfer. Helps with sound deadening as well.
Do need to be careful around the pillars when removing the side airbags.
When you go to reinstall, I recommend you install new and thicker insulation in the roof as well. I believe the heat transference from the sun hitting the roof is the primary cause for glue failure on the headliner. The rooftops could have stood to have better/more insulation to reduce the heat transfer. Helps with sound deadening as well.
I paid a local shop $750 to replace the headliner about 2 months ago. Came out beautifully.
Paying up was preferable to spending 8 hours struggling with it myself, and probably breaking some of the fiddly trim bits in the process.
Paying up was preferable to spending 8 hours struggling with it myself, and probably breaking some of the fiddly trim bits in the process.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)








