Jaguar seems to have outdone itself once again by making it a royal PITA to replace a simple brake wear sensor on the rear of the XE. The connector end seems to disappear into the abyss and I am unable to see where it is, much less get to it. Anyone happen to know how to get to it? It this something more easily done with a lift perhaps?

Sharing any thoughts/experiences would be much appreciated!

 

Its on the top side of the rear subframe right in front of the axle. Definitely a lot easier with a lift. Its plastic clipped to subframe to prevent movement. Can be a pain but is easily seen under vehicle.

 

Thanks, much obliged, I figured I’d be able to see better up on the lift, just hoping my fingers will fit. Not sure it would’ve taken much for Jaguar to make it more accessible but oh well.

Cheers!