please forgive me if this has been addressed by another thread.

however i have been reading for hours now and can not seem to find an answer that fits.

2004 XJR 200k miles
replaced all 4 corners with Arnot next gen over the last 2 years. replace front ride hight sensor recently trying to address the leaning issue.
swaped one side to another both sensors and struts. bled all lines at valve block and reseated all hoses at block and air tank.
and it still leans on drivers side. no air is leaking at any of the points. all lines holding air. pump is working. goes without saying i get air suspension fault shortly after starting car.

i really love the car i do not want to get rid of it because of this. however, i have spent too much time on this issue already and frankly i am getting too old and tired.
any help is appreciated.

again if this issue was addressed some where else forgive me that i missed it

Need to get the heights recalibrated via Jaguar software

Or do what I did I had the drivers side HIGHER then passenger and I just adjusted the height sensors to get it level.

Been fighting with it for to long
now has been resolved
took to dealer and apparently a plug was not seated properly
they did not share which one

thank you for the assist

Do you mean that the driver's side of the car was higher than the passenger's when the car was level,
or that you parked it so the driver's side was on higher ground and then did something with the sensors?
And how did you adjust the height sensors?

What kind of plug?