I need to pull up the carpet in the rear of my 1997 XJ6 to fix a rust hole. I have pulled the passenger's seat out of the car and the trim on the B-pillar but I need to remove the door sill plates next. I thought the "=====JAGUAR=====" stainless steel trim plates were just held on with magnets but I am not able to get them to come off by prying at the edge and I am bending this plate in trying to do this. Is there a trick to getting these off so I can get to the screws underneath that stainless trim panel?

Any hints or suggestions would be most welcome.

 

is the way...they're stuck on with double sided tape, and they are very thin. Best to use a hair dryer and pull up progressively.
Good Luck !

 

I guess this is the same info request????

https://forums.jag-lovers.com/t/how-...lates/349699/2

I answered this question a few days ago.

bob