the myth of warped discs
It's time to stop
and to move on. You can believe whatever you want.
I agree with jahummer. OEM quality cast iron rotors usually don't warp; there are other causes for steering wheel vibration when braking. See my Post #5 and the links to the old threads therein.
https://www.jaguarforums.com/forum/x...r-5-0l-246827/
The metallurgy of cast iron rotors varies, and aftermaket rotors can overheat and warp, particularly if they're cheap. You simply can't tell just by looking.
https://www.knowyourparts.com/techni...-damage-noise/
This thread is warped!
I agree with jahummer. OEM quality cast iron rotors usually don't warp; there are other causes for steering wheel vibration when braking. See my Post #5 and the links to the old threads therein.
https://www.jaguarforums.com/forum/x...r-5-0l-246827/
The metallurgy of cast iron rotors varies, and aftermaket rotors can overheat and warp, particularly if they're cheap. You simply can't tell just by looking.
https://www.knowyourparts.com/techni...-damage-noise/
This thread is warped!
This really seemed unnecessary and out of bounds. In the end this is just an internet forum and a thread about rotors, a condition of membership and participation is not contingent on agreeing with you. If you are unable to contain your emotions and refrain from personal attacks perhaps you are the one who needs a break.
"Opinion" my ***-hole. My eyes are not an opinion. Look at that other thread.... Warped does not have to mean Warped By Heat Exclusively. Warped means the end product from an outside source that caused deformation.
Sheesh. If the internet told you 0100110 = 38, you'd probably believe it. If nine people out of ten said 19x7=199, that does not make it true.
Sheesh. If the internet told you 0100110 = 38, you'd probably believe it. If nine people out of ten said 19x7=199, that does not make it true.
Psssst......climate change!
I'll hang up and listen!
Thread
Thread Starter
Forum
Replies
Last Post
JimC64
X-Type ( X400 )
1
May 12, 2012 10:20 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)







