Power Mirror Problems
#1
Power Mirror Problems
I read some of the entries in this forum and have not seen this problem addressed.
My power mirrors only go one direction, up and out. Once out, I have to move them manually back into position.
I tried to pull the mirror out to look at the motor inside and it is so tight I am afraid it will break.
Any ideas?
My power mirrors only go one direction, up and out. Once out, I have to move them manually back into position.
I tried to pull the mirror out to look at the motor inside and it is so tight I am afraid it will break.
Any ideas?
#2
#3
I agree, usually it is a dirty switch. See https://www.jaguarforums.com/forum/x...control-63646/ for a rebuild technique (Caution lots of small bits that can easily get lost).
#5
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)