Jaguar Forums - Jaguar Enthusiasts Forum
0 2018/10/03 08:23:22
I couldn't be too picky about the muffler, it had to be short and with offset inlets and outlets. This one fit the bill exactly. I was afraid it might be too noisy (in non-cutout mode that is) but it's no louder than the stock muffler was.
I couldn't be too picky about the muffler, it had to be short and with offset inlets and outlets. This one fit the bill exactly. I was afraid it might be too noisy (in non-cutout mode that is) but it's no louder than the stock muffler was.
0 2018/10/03 08:23:48
The cutout and the cutout motor assembly are both Summit Racing parts. I've not done the wiring yet, thus the hanging cable. The stock exhaust system can be seen in the background.
The cutout and the cutout motor assembly are both Summit Racing parts. I've not done the wiring yet, thus the hanging cable. The stock exhaust system can be seen in the background.
0 2018/10/03 08:23:55
I'll probably have a hard time finding a pipe to point the exhaust down from the cutout, so I make end up making my own. I'm not that great of a welder, but nobody will see it anyway.
I'll probably have a hard time finding a pipe to point the exhaust down from the cutout, so I make end up making my own. I'm not that great of a welder, but nobody will see it anyway.
0 2018/10/03 08:24:03
0 2018/10/03 09:09:45
0 2018/10/03 09:12:15
Both the exhaust cutout and the cutout switch assembly are Summit Racing products. I've not done the wiring yet, thus the hanging cable. The angle of this photo makes the cutout motor assembly look much lower than it actually is. The stock exhaust setup can be seen in the background.
Both the exhaust cutout and the cutout switch assembly are Summit Racing products. I've not done the wiring yet, thus the hanging cable. The angle of this photo makes the cutout motor assembly look much lower than it actually is. The stock exhaust setup can be seen in the background.
0 2018/10/03 09:13:57
I doubt that I'll find a premade tailpipe to divert the exhaust gas down, so I may have to make one myself. It's a pretty tight fit in there. I'm not all that great of a welder, but nobody will be able to see it anyway.
I doubt that I'll find a premade tailpipe to divert the exhaust gas down, so I may have to make one myself. It's a pretty tight fit in there. I'm not all that great of a welder, but nobody will be able to see it anyway.
0 2018/10/03 09:13:57
My requirement for shopping for a new muffler were simple, as short as possible with offset intakes out outlets. I was afraid that they might turn out to be too loud (in non-cutout mode that is) but they are no louder than the stock mufflers.
My requirement for shopping for a new muffler were simple, as short as possible with offset intakes out outlets. I was afraid that they might turn out to be too loud (in non-cutout mode that is) but they are no louder than the stock mufflers.
0 2018/10/03 09:13:57