Jaguar Forums - Jaguar Enthusiasts Forum
0 2021/01/28 11:50:43
0 2021/01/17 00:07:18
0 2021/01/17 00:06:35
showing the starter motor position
showing the starter motor position
0 2021/01/14 06:50:04
Socket and long lever on the crank pulley
Socket and long lever on the crank pulley
0 2021/01/14 06:49:20
0 2021/01/07 23:28:07
0 2021/01/03 05:44:08
0 2021/01/03 05:43:27
0 2021/01/01 11:03:41
0 2020/12/31 06:33:18
0 2020/12/31 06:32:47
0 2020/12/31 06:32:16
0 2020/12/31 06:14:09
0 2020/12/31 06:13:36
0 2020/12/31 06:12:58
Interestingly, these brand new liners are not yet honed for oil retention. Luckily I have a Flex-Hone in stock for this requirement, if a new replacement liner is needed.
Interestingly, these brand new liners are not yet honed for oil retention. Luckily I have a Flex-Hone in stock for this requirement, if a new replacement liner is needed.
0 2020/12/31 06:12:19
0 2020/12/27 05:20:39
0 2020/12/27 05:20:00
0 2020/12/27 05:19:29
0 2020/12/27 05:18:06
0 2020/12/27 05:17:29
0 2020/12/27 05:16:54
Don't say you don't want one!"
Don't say you don't want one!"
0 2020/12/27 01:26:53
Earth top left; gauge bottom left, warning light right.
Earth top left; gauge bottom left, warning light right.
0 2020/12/27 01:15:31
0 2020/12/15 05:29:34
0 2020/12/11 02:28:17
70 amp Relay above radiator, 12v from the fuse box, triggered by the water pump inlet switch. OEM fan wires to be on with the aircon compressor.
70 amp Relay above radiator, 12v from the fuse box, triggered by the water pump inlet switch. OEM fan wires to be on with the aircon compressor.
0 2020/11/28 23:39:14
Blue wire is feed from firewall post
Blue wire is feed from firewall post
0 2020/11/28 23:38:10
A LHD ZF steering rack for an XJS
A LHD ZF steering rack for an XJS
0 2020/11/16 09:03:39
I shall connect the 1/2 inch diameter hose to this shortened pipe with two clips for security, as it has no flared end.
I shall connect the 1/2 inch diameter hose to this shortened pipe with two clips for security, as it has no flared end.
0 2020/11/15 04:50:28
The epoxied fuel supply fitting then has its flare nut threads coated with epoxy and is screwed into the tank connector. In effect, following Grant's advice, I have made a solid tank exit pipe, analogous to the later OEM welded tank exit pipe.
The epoxied fuel supply fitting then has its flare nut threads coated with epoxy and is screwed into the tank connector. In effect, following Grant's advice, I have made a solid tank exit pipe, analogous to the later OEM welded tank exit pipe.
0 2020/11/15 04:49:47
Flare nut expoxied onto the fuel pipe which has been shortened.
Flare nut expoxied onto the fuel pipe which has been shortened.
0 2020/11/15 04:49:07
Fuel tank floor soldered all over by the local rad specialist and then being painted
Fuel tank floor soldered all over by the local rad specialist and then being painted
0 2020/11/10 08:10:25
The pump inlet is at the back of the boot, I used the USA piece to fit it, cut into two pieces, with a straight joiner to connect them, to give me the exact shape needed.
The pump inlet is at the back of the boot, I used the USA piece to fit it, cut into two pieces, with a straight joiner to connect them, to give me the exact shape needed.
0 2020/10/29 05:22:08
Here it is
Here it is
0 2020/10/21 04:58:31
general view
general view
0 2020/10/21 04:57:57
Moved to be more visible
Moved to be more visible
0 2020/10/21 04:57:16
Tiny nut blocking the hinge edge where it overlaps the fixed part bolted to the car
Tiny nut blocking the hinge edge where it overlaps the fixed part bolted to the car
0 2020/10/21 04:56:35
close up of modulator with vac line not yet attached.
close up of modulator with vac line not yet attached.
0 2020/10/14 07:26:49
The modulator is on the left in the photo (the gold coloured thing sticking out of the side with the blue vac line running down to the elbow plugged into it). This photo is from the front of the car looking rearwards, the modulator is on the RHS and is easily accessible from under the car.
The modulator is on the left in the photo (the gold coloured thing sticking out of the side with the blue vac line running down to the elbow plugged into it). This photo is from the front of the car looking rearwards, the modulator is on the RHS and is easily accessible from under the car.
0 2020/10/14 07:23:34