My Post Pictures

July 2, 2016

18

0

I had these made - 285/35X18" I could not get a business card in there when the suspension is compressed

I had these made - 285/35X18" I could not get a business card in there when the suspension is compressed

0 2016/07/02 18:28:04 dc4prez

I opted for the rounded corners - I have stainless headers and these remove all of the latent heat from the engine compartment - I like yours also

I opted for the rounded corners - I have stainless headers and these remove all of the latent heat from the engine compartment - I like yours also

0 2016/07/02 18:28:24 dc4prez

0 2016/07/02 18:39:48 dc4prez

0 2016/07/03 03:00:40 dc4prez

0 2016/07/03 03:11:13 dc4prez

0 2016/07/04 01:55:01 dc4prez

0 2016/07/04 01:55:03 dc4prez

0 2016/07/04 02:40:11 dc4prez

0 2016/07/04 23:54:06 dc4prez

cut xmember - modify a/c vent

cut xmember - modify a/c vent

0 2017/06/19 08:15:17 dc4prez

piece of xmember that was removed

piece of xmember that was removed

0 2017/06/19 08:16:30 dc4prez

0 2017/06/19 08:16:32 dc4prez

dogs breakfast - there is no room for all the wiring, plus the Air bag processor

dogs breakfast - there is no room for all the wiring, plus the Air bag processor

0 2017/06/19 08:16:41 dc4prez

new face plate before bending

new face plate before bending

0 2017/06/19 08:16:43 dc4prez

my foot -but you can see how much lower the opening is, in relationship to the shifter

my foot -but you can see how much lower the opening is, in relationship to the shifter

0 2017/06/19 08:18:01 dc4prez

had to fibreglass centre console because the facure was lower and more recessed than original - also had to remove material from A/C vent and remake it with 1mm alloy and shit loads of Sika291 - both top corners

had to fibreglass centre console because the facure was lower and more recessed than original - also had to remove material from A/C vent and remake it with 1mm alloy and shit loads of Sika291 - both top corners

0 2017/06/19 08:19:15 dc4prez

note the bend at the front of the shifter, I needed to lower it about 16 - 20mm. There is enough trim glued on unseen side to peel it back and fibreglass extended wings(?)

note the bend at the front of the shifter, I needed to lower it about 16 - 20mm. There is enough trim glued on unseen side to peel it back and fibreglass extended wings(?)

0 2017/06/19 08:19:18 dc4prez

it looks factory fitted

it looks factory fitted

0 2017/06/19 08:19:21 dc4prez