Jaguar Forums - Jaguar Enthusiasts Forum
Steering column seal
Steering column seal
0 2021/08/30 04:10:24
All good on the head gasket check
All good on the head gasket check
0 2021/08/28 16:13:25
Hopefully that's fixed it
Hopefully that's fixed it
0 2021/08/28 16:13:21
Took about 2mm off the inside edge of the pin as there's not much leeway when installed
Took about 2mm off the inside edge of the pin as there's not much leeway when installed
0 2021/08/18 13:31:09
Trimmed the split washers with a Dremel and flattened then slightly too, with a couple of slaps of a hammer.
Trimmed the split washers with a Dremel and flattened then slightly too, with a couple of slaps of a hammer.
0 2021/08/18 13:31:03
Glued them in! Probably easier to weld the hole and recut but I wasn't in a welding mood 😁
Glued them in! Probably easier to weld the hole and recut but I wasn't in a welding mood 😁
0 2021/08/18 13:30:58
0 2021/08/05 04:38:29
0 2021/08/03 15:48:41
0 2021/08/03 15:48:37
0 2021/08/03 15:44:22
Change the air filter
Change the air filter
0 2021/02/20 12:45:39
Out with the old, in with the less old but not screaming diff
Out with the old, in with the less old but not screaming diff
0 2020/12/12 09:56:41
Needed to use a hub puller this time round. Although that needed grinding so it would fit. Literally fell out last year.
Needed to use a hub puller this time round. Although that needed grinding so it would fit. Literally fell out last year.
0 2020/11/27 01:48:17
0 2020/11/06 03:23:34
0 2020/11/06 03:21:01
0 2020/10/01 13:38:36
0 2020/10/01 13:30:52
0 2020/10/01 13:30:41
0 2020/10/01 13:30:31
upper control arm bush removal 03 waling on the metal so that it can be pulled out
upper control arm bush removal 03 waling on the metal so that it can be pulled out
0 2020/09/16 03:09:35
upper control arm bush removal 02 clearing the remaining rubber before cutting into the metal
upper control arm bush removal 02 clearing the remaining rubber before cutting into the metal
0 2020/09/16 03:09:33
upper control arm bush removal 01 pushing out the centre piece
upper control arm bush removal 01 pushing out the centre piece
0 2020/09/16 03:09:31
lower control arm bush removal 04 finally, you beat it.
lower control arm bush removal 04 finally, you beat it.
0 2020/09/16 03:09:29
lower control arm bush removal 03 cutting slots in the metal remaining
lower control arm bush removal 03 cutting slots in the metal remaining
0 2020/09/16 03:09:27
lower control arm bush removal 02 pulling out the metal centre piece after drilling
lower control arm bush removal 02 pulling out the metal centre piece after drilling
0 2020/09/16 03:09:25
lower control arm bush removal 01 drilling out the metal rubber middle bit
lower control arm bush removal 01 drilling out the metal rubber middle bit
0 2020/09/16 03:09:22
Front wheel bearing replace and refurb
Front wheel bearing replace and refurb
0 2020/07/05 01:28:52
Cats connectors
Cats connectors
0 2020/04/10 10:29:51
Checking the cats with jaguar sdd
Checking the cats with jaguar sdd
0 2020/04/10 10:29:16
0 2020/04/10 10:25:00
Rear eccentric bolt
Rear eccentric bolt
0 2020/03/29 03:47:19
Plastic fitting to wing mirror glass
Plastic fitting to wing mirror glass
0 2020/02/01 10:52:29
Front tracking with the tape measure. (Use some sticky tape to hold the other end in the groove)
Front tracking with the tape measure. (Use some sticky tape to hold the other end in the groove)
0 2020/01/19 05:15:54
1595 rear vs 1600 front, so toe out at the moment. Needs to be the opposite to that.
1595 rear vs 1600 front, so toe out at the moment. Needs to be the opposite to that.
0 2020/01/12 10:41:29
Digital measurement for camber
Digital measurement for camber
0 2020/01/12 10:38:06
0 2019/12/03 01:37:09
Headlight adjustment screw
Headlight adjustment screw
0 2019/11/17 14:10:44
New ems fuse box and cleaned up contacts
New ems fuse box and cleaned up contacts
0 2019/10/25 11:21:07
Engine management relay
Engine management relay
0 2019/10/19 14:31:53
Front suspension diagram
Front suspension diagram
0 2019/10/11 14:39:28