Jaguar Forums - Jaguar Enthusiasts Forum
0 2017/01/10 18:56:30
0 2017/01/10 18:56:21
0 2017/01/10 18:56:15
0 2017/01/10 18:56:05
Too cold to pour water so have to wait till it warms up to examine area again
Too cold to pour water so have to wait till it warms up to examine area again
0 2017/01/10 18:49:09
Silt on harness directly below drain channel guide
Silt on harness directly below drain channel guide
0 2017/01/10 18:48:59
General condition of inner wing
General condition of inner wing
0 2017/01/10 18:48:52
A better view of the "wet spot" and a silt deposit that runs down the harness
A better view of the "wet spot" and a silt deposit that runs down the harness
0 2017/01/10 18:48:45
0 2017/01/10 18:44:54
Traces of moisture here
Traces of moisture here
0 2017/01/10 18:29:14
Sunroof drain tube (cut short) upper rt ..wiring harness apertures at left.
Sunroof drain tube (cut short) upper rt ..wiring harness apertures at left.
0 2017/01/10 18:21:22
Windscreen seal quite slack at this corner ..could this be the entry point?
Windscreen seal quite slack at this corner ..could this be the entry point?
0 2016/12/30 15:46:56
Windscreen corner with plastic plenum cover removed. Clean.
Windscreen corner with plastic plenum cover removed. Clean.
0 2016/12/30 15:46:50
plenum crevice - drain to duckbill at far left - foam washer wire insulation upper left. Whole area clean with no rust evident.
plenum crevice - drain to duckbill at far left - foam washer wire insulation upper left. Whole area clean with no rust evident.
0 2016/12/30 15:39:11
rear side of plenum
rear side of plenum
0 2016/12/30 15:39:03
0 2016/12/29 00:23:18
Repaired unit ready to install in the car.
Repaired unit ready to install in the car.
0 2016/11/19 22:08:11
Mounting the replacement bucket
Mounting the replacement bucket
0 2016/11/19 22:07:09
Always leave a bit of putty on the side to test for set-up hardness - in this case after about 3 hours it was hard but not too hard to trim with a sharp razor-knife.
Always leave a bit of putty on the side to test for set-up hardness - in this case after about 3 hours it was hard but not too hard to trim with a sharp razor-knife.
0 2016/11/19 21:59:59
Water based putty can be molded with wet tools
Water based putty can be molded with wet tools
0 2016/11/19 21:59:44
This stuff sets rock hard and is usually used for porcelain repair
This stuff sets rock hard and is usually used for porcelain repair
0 2016/11/19 21:59:23
luckily one or two threads left so I could get the correct angle for repair
luckily one or two threads left so I could get the correct angle for repair
0 2016/11/19 21:51:33
bottom centre bucket mount sheared off
bottom centre bucket mount sheared off
0 2016/11/19 21:50:36
full-on foam buffer crumble, zero buffer remaining
full-on foam buffer crumble, zero buffer remaining
0 2016/10/06 08:54:57
tranny mount with tell-tale crumble signs ...
tranny mount with tell-tale crumble signs ...
0 2016/10/06 08:54:52
0 2016/10/06 00:13:08
1988 sovereign
1988 sovereign
0 2016/10/02 16:32:27
0 2016/09/28 21:47:33
0 2016/09/28 21:46:58
0 2016/09/28 21:45:53
0 2016/09/28 21:45:43
0 2016/09/28 21:45:09
0 2016/09/28 21:45:04
0 2016/09/28 21:44:05
0 2016/09/28 21:43:57
front hub
front hub
0 2016/09/28 21:42:03
front springs and pans
front springs and pans
0 2016/09/28 21:41:33
rack part number and manufactured date
rack part number and manufactured date
0 2016/09/28 21:40:36
steering rack
steering rack
0 2016/09/28 21:40:13
ratio tag, need to clean it up but I think it says 3.86?
ratio tag, need to clean it up but I think it says 3.86?
0 2016/09/28 21:37:20