Jaguar Forums - Jaguar Enthusiasts Forum
Removing the trans flange bolts requires 2 wrenches due to no room.
Removing the trans flange bolts requires 2 wrenches due to no room.
0 2017/12/11 20:51:42
These bolts are on tight, the bolt side is 18mm, the nut side is 17mm always if possible loosen or tighten on the nut side and hold on the bolt side. I braced the wrench against the body and loosen with a 1/2in ratchet with a 12in cheater to undo the drive shaft bolts.
These bolts are on tight, the bolt side is 18mm, the nut side is 17mm always if possible loosen or tighten on the nut side and hold on the bolt side. I braced the wrench against the body and loosen with a 1/2in ratchet with a 12in cheater to undo the drive shaft bolts.
0 2017/12/11 20:44:04
Before you separate the shaft from the trans mark the drive shaft yoke and trans output shaft, you want this to go back EXACTLY the same way you took it apart. Note the arrow on the flex joint points at a flange.
Before you separate the shaft from the trans mark the drive shaft yoke and trans output shaft, you want this to go back EXACTLY the same way you took it apart. Note the arrow on the flex joint points at a flange.
0 2017/12/11 20:40:25
The trans mount was also shot.
The trans mount was also shot.
0 2017/12/11 20:33:16
Flex joint exposed, this also let me look at the drive shaft it total by using a mirror and flashlight to look down the heat shield. Yes it was time for a new flex joint.
Flex joint exposed, this also let me look at the drive shaft it total by using a mirror and flashlight to look down the heat shield. Yes it was time for a new flex joint.
0 2017/12/11 20:30:26
Un bolt the cross member (4 bolt to body , 2 to trans).
Un bolt the cross member (4 bolt to body , 2 to trans).
0 2017/12/11 20:27:59
The plate I use to jack against oil and trans pans. It only needs to be hand tight jacked against the pan. Once the trans cross member is removed it will drop about an inch.
The plate I use to jack against oil and trans pans. It only needs to be hand tight jacked against the pan. Once the trans cross member is removed it will drop about an inch.
0 2017/12/11 20:22:52
Flex joint, Trans mount and Trans cross member.
Flex joint, Trans mount and Trans cross member.
0 2017/12/11 20:22:14
DO NOT START THE CAR WITH THE DRIVE SHAFT DIS CONNECTED.
DO NOT START THE CAR WITH THE DRIVE SHAFT DIS CONNECTED.
0 2017/12/11 20:12:20
Your going to need to get the car up on either rams or jack stands, You will also need to activate the emergency parking brake release since to remove all of the flex joint bolts the drive shaft must be able to turn. One or both of the rear wheels need to be off the ground (Yes its an open diff) to turn the drive shaft also.
Your going to need to get the car up on either rams or jack stands, You will also need to activate the emergency parking brake release since to remove all of the flex joint bolts the drive shaft must be able to turn. One or both of the rear wheels need to be off the ground (Yes its an open diff) to turn the drive shaft also.
0 2017/12/11 20:11:39
The parts I started out with, Flex joint Trans mount
The parts I started out with, Flex joint Trans mount
0 2017/12/11 20:03:32
Rear CV bolts and a plate I made at the job to jack up the trans buy the pan.
Rear CV bolts and a plate I made at the job to jack up the trans buy the pan.
0 2017/12/06 22:08:28
Oh Boy!
Oh Boy!
0 2017/12/05 21:43:24
LT4 Specs
LT4 Specs
0 2017/12/05 09:23:47
The CTSV 650hp Supercharged LT4
The CTSV 650hp Supercharged LT4
0 2017/12/05 09:22:13
I really need a project to put something like this in, a Supercharged LS made to look like a smallblock Chevy.
I really need a project to put something like this in, a Supercharged LS made to look like a smallblock Chevy.
0 2017/12/05 09:20:04
808hp!
808hp!
0 2017/12/05 09:12:58
The Demon V8
The Demon V8
0 2017/12/05 09:12:08
The Ford GT Props to Ford, To win LeManns 1-2-3 50 years ago, and then PREDICT and win LeManns AGAIN on the 50th anniversary is quite a feat.
The Ford GT Props to Ford, To win LeManns 1-2-3 50 years ago, and then PREDICT and win LeManns AGAIN on the 50th anniversary is quite a feat.
0 2017/12/05 09:07:47
Saleen 1
Saleen 1
0 2017/12/05 09:06:43
The Saleen 1 Weighs 2800lbs and is powered by a 455hp turbo 4 that is of a Saleen design.
The Saleen 1 Weighs 2800lbs and is powered by a 455hp turbo 4 that is of a Saleen design.
0 2017/12/05 09:03:30
Loving this 911
Loving this 911
0 2017/12/05 09:02:23
The new Lexus LS500
The new Lexus LS500
0 2017/12/05 09:01:41
The new Lexus LS500
The new Lexus LS500
0 2017/12/05 09:00:42
ZR1 Vette 755hp & 750ftlb. Supercharged LT5 6.2l 212mph top speed.
ZR1 Vette 755hp & 750ftlb. Supercharged LT5 6.2l 212mph top speed.
0 2017/12/05 08:57:04
ZR1 Vette
ZR1 Vette
0 2017/12/05 08:56:44
$95 for the part, Genuine SGF , $100 to install it. $500 to rebuild and balance your current drive shaft. They also service diffs.
$95 for the part, Genuine SGF , $100 to install it. $500 to rebuild and balance your current drive shaft. They also service diffs.
0 2017/11/30 18:38:57
They will sell you the part for $95, install it for $100 and rebuild and balance your driveshaft for $500 which is still less than a jag replacement.
They will sell you the part for $95, install it for $100 and rebuild and balance your driveshaft for $500 which is still less than a jag replacement.
0 2017/11/30 18:17:37
0 2017/10/27 23:47:27
0 2017/09/20 13:01:24
The bypass valve is the gold circle, It's job is to bleed of boost when your not needing boost. but if it's out of adjustment it can bleed off boost all the time. It's a pain but it can be adjusted while on the car.
The bypass valve is the gold circle, It's job is to bleed of boost when your not needing boost. but if it's out of adjustment it can bleed off boost all the time. It's a pain but it can be adjusted while on the car.
0 2017/09/14 10:23:20
Getting these faults now,researching the problem, but the car starts an runs great and the battery is being charged as Torque app verified.
Getting these faults now,researching the problem, but the car starts an runs great and the battery is being charged as Torque app verified.
0 2017/09/12 11:07:32
Rebuilt 250 amp alt in.
Rebuilt 250 amp alt in.
0 2017/09/12 11:05:55
Shout out to Quality power, this is my 6th item from them (4 alts, 2 starters) They can rebuild the Jag alt to stock 150 or 250 or 320 amps.
Shout out to Quality power, this is my 6th item from them (4 alts, 2 starters) They can rebuild the Jag alt to stock 150 or 250 or 320 amps.
0 2017/09/12 11:00:36
The numbers needed to rebuilt it.
The numbers needed to rebuilt it.
0 2017/09/12 10:59:31
Very easy alt access with only 3 bolts holding it on.
Very easy alt access with only 3 bolts holding it on.
0 2017/09/12 10:58:40
Since the alt can now put out so much power Quality Power in Yucaipa CA. reccomends running and additional positive cable to the battery, or to the positive side of the starter if the battery is in the trunk, as in the XF
Since the alt can now put out so much power Quality Power in Yucaipa CA. reccomends running and additional positive cable to the battery, or to the positive side of the starter if the battery is in the trunk, as in the XF
0 2017/09/12 07:10:55
un shielded cable routing
un shielded cable routing
0 2017/09/12 07:09:56
Gonna be reinstalling this now that I have it shielded.
Gonna be reinstalling this now that I have it shielded.
0 2017/09/12 07:08:42
Rebuilt alt in car. While I had everything out of the way to do the water pump and rear crossover (S/C service) might as well tackle my 80kmi alt right.lol
Rebuilt alt in car. While I had everything out of the way to do the water pump and rear crossover (S/C service) might as well tackle my 80kmi alt right.lol
0 2017/09/12 07:04:44