I went to ADV.1 website and I can't find these wheels but I really like them. Any help on what this actually is?

 

Dragonfire 6 what are the wheels and sizes on the red one? I tried to find them on the ADV.1 website and could not find them,

 

love em can u plz send me the size and brand thanks in advance

 

any pic of it up ???

 

I’m feeling like one of the only ones that actually like the optional wheels from Jaguar that came on my car.

I know the tires need some dressing, but this thread is about the wheels.

 

Nah...Not the only one. Some of the AM wheels look great on the cars...But many of them look JANK on these cars! Always a personal preference though. Those look nice.👍

DC

 

I'm with you...love the looks of the Gyrodine wheels but am swapping them over to aftermarket due to weight. If they were 5 lbs less, then I wouldn't even think of changing them but a 10lbs difference is a lot.

 

I really like these wheels too, and had them, just thought they were heavy so I kept the other set I got with my car. They were orange with black, but a poor attempt at color matching so I finally got them powdercoated all black.

 

adv10 m.v2 CS
20x11.5 ET33
20x9 ET40

 

How many lbs have this wheel? It looks nice, very nice... I'm searching wheels with less wight as my OEM Gyrodyne 20" thank you so much
BR Andi

 

it weighs 28lbs (13.5kg)

 

I like the rotors. Are they Power Stop?

 

They are stoptech*
weights below

 

This weights are in kg from your Brakes I think?
OEM front 17,5 kg, back round about 15kg, I´m not sure in the back weight.
You save round about each side front and rear 3-4 kg max.
Have you tested run times 0-60miles or 100-200km/h what does this save brings?

 

you are right. Those are in kg. Been having issues Since i got my draggy and it hapenned to be just an oxygen sensor issue. With the issue, the best i got was a 7.8s 100-200 time with 95RON octane fuel. No wheels, no meth. It had an upper pulley, ITG maxogen COI, and 200 cell downpipes (vap tune as well). It also was windy and on a 0.4 degrees incline. Gonna replace all sensor 1s banks 1&2 then make a run with 95octane, and 95 w/meth all while data logging to fine tune my car with VAP. Maybe a 98 octane fuel later too. I can report the numbers i get if that will help you in any way.

oh and the wheels saved me a few pounds of weight too. Mine weigh 28lbs(cs series wheels are made to be load specific, thus, in my case slightly heavier). I had gyrodines, which people measured in a range between 42-32 lbs. not sure who’s right. gonna measure them later myself

 

 

this wheel is 26lbs for the 11.5” width. I have also just changed the color

 

Those look very close to my Forge 8 wheels with 305s on the back