Noel, the center console (armrest) with the cupholder was in bad condition, leather was shot, and it was tossed out. I did pull the cupholder but it has been sold.

The drivers seat base - not sure what you mean, but I tossed out the seat and the metal framework so I don't think I have that either.

 

I have a mina air filter setup, and I would like to return to stock, for my 99 XK8. Do you have the parts to do this? It would require everything from the throttle body neck connection, to the air filter box. I do not need the electrical part of the mass air flow sensor, since I just got a new one.........Thanks......Mike

 

Do you happen to have...
Amber fender marker lamps?
Black tonneau cover storage bag?

Thanks in advance.

 

PMs sent Mr Plow and CPE.

Now that's in my head all day: Mr Plow, that's my name, that name again is Mr Plow!

 

How about the drivers side window switch and a rear view mirror

 

Tex, sorry I didn't see this earlier. Driver window switch is gone, I do have the mirror. It is pn HJA3121AA. PM me if that will work for you. I believe the light sensor still works, but it has been over a year since I drove it so IDK for sure.

 

CyJag, No worries I think I have a mirror located locally but haven't seen it yet. Can you PM me a price.

 

Both of mine were cracked too. Took broken pieces to a friend with a 3-D printer. He copied the old ones and "printed" me two new ones that are far stronger than original!

 

Any chance the driver's door mirror is available?

 

PM sent TArring. It is still available.

 

All,

I will be done parting this car soon, and will re-post a full and updated list to a new thread at that time.

If anyone has any large item wants, let me know. Much of the heavy stuff is going with the car, as it's beyond my skill level and/or desire to fool with it. E.g. suspension parts, transmission, engine block, etc.

I do have most of the small stuff and trim off it already.

 

Hi,
I need as much of the engine liner as possible. Previous owner had a rat in there that chewed holes in the fabric liners. (fenders, hood, etc).
Also I need a metal post that the convertible top cover snaps onto.

Any luck?

 

BJR- my fabric liners also have some rodent damage, and the hood liner went with the hood. So no luck there, sorry.

On the metal post, I am having trouble understanding what you mean. Here's a diagram:


The top has 3 posts with holes in them (items 4 and 6), and those all slide into the latch assembly (item 8) which runs the width of the top of the windshield. I have all those items, as well as #9. Is one of those what you are looking for, or am I in the wrong area?

 

Here is a picture of one of two that I have. It is the little "nipple" post that would be next to a rear quarter panel window in the back seat. The top cover (convertible boot) snaps into it when the roof is in an open position.

Thanks

 

Underneath the front seat cushions there is a rubber pad.This piece attaches with hooks on two sides and it gives support to the seat. Any chance you kept these?

 

B Dunn, sorry I can't find that thing. Must have tossed it before I started saving bolts and screws and such.

Noelstone, I know the piece you mean, but threw them out with the seat stuff. Sorry.

It's always the stuff you DON'T think would ever be needed....

 

Noelstone,
just was looking at my pile of stuff, and I DO have the lumbar supports, which attach with hooks. But I think these are on the back not the bottom. But just in case that's what you meant and I misunderstood.

They are shown here with some other parts, is this what you are looking for by chance?

 

Yes those are similiar but they are for the back.

My trim color is SDZ, I'm looking for a hinge cover but not sure if thats the same color.

Also I need the exterior metal trim piece for the rear passenger side.

 

On the hinge cover, if it is for the outside (by the door) for either seat, no luck - mine were also broken. I do have the INNER for the driver seat, but it is not same as the outer for pass or driver side.

As far as color, I am not 100% sure what SDZ is but I am guessing it is in the beige family. I was NDR "cream" but a lot of stuff is the same across all the oatmeal / cream / cashmere / coffee lines - they share colors for different trim bits. If the cover I have is what you want I can send a pic, but it is definitely beige.

On the outer waist seal, sorry my RH is sold, only have the LH now.

 

Closing this thread - will open a new one with the latest and last list of parts. Car is now gone, but still have lots of parts in storage in the garage!

Please see the new thread started on 21 Oct 2016 for parts.

Thanks to all who have inquired and purchased!