Intake Gaskets
#1
Intake Gaskets
So in my haste reinstalling the supercharger, I didn't reattach the rear bracket that goes onto the back of the supercharger.
To say it's a pain to work back there is an understatement. I was determined to do it without taking off the super charger again, but this idea has run it's course.
So my question to the hivemind. Is it safe to reuse the new intake gaskets that I installed and torqued down already?
I was hoping to button everything up today and really don't want to have to wait for replacement parts to arrive.
To say it's a pain to work back there is an understatement. I was determined to do it without taking off the super charger again, but this idea has run it's course.
So my question to the hivemind. Is it safe to reuse the new intake gaskets that I installed and torqued down already?
I was hoping to button everything up today and really don't want to have to wait for replacement parts to arrive.
#2
#4
Original plastic or alloy rear header pipe?
https://www.jaguarforums.com/forum/x...e-3-0l-279686/
Very unlucky if it is.
In answer to you first question, NO the gaskets are crush type, one use only. Which did not stop JLR from reusing them and applying RVT sealant all over.
As I found out on removal of the supercharger..
#5
Thread
Thread Starter
Forum
Replies
Last Post
androulakis
S-Type / S type R Supercharged V8 ( X200 )
16
03-31-2010 01:31 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)