Custom ignition switch build
#1
Custom ignition switch build
'76 XJS 5.7 SBC conversion. My ignition switch has failed me for the last time. It is coming apart and is un-repairable. I looked for replacements and can only find one for $300. Not happening. I want to make my own using switches but don't know what the wires are going to the ignition switch. There are six total wires: white, white pink, white yellow, brown (14 GA), brown (12 GA), brown red. Can anyone tell me where these wires go?
#2
This should help a bit;
On the XJS, Black wires are usually Ground/Earth and Brown wires are B+. Using the chart below and can figure out the colors codes for all of the wires;
Example - WY = White/Yellow
N = Brown
B = Black
W = White
K = Pink
G = Green
R = Red
Y = Yellow
O = Orange
S = Slate (Grey)
L = Light (e.g. Light Blue, Light Green etc.)
P = Purple
U = Blue
Mark
On the XJS, Black wires are usually Ground/Earth and Brown wires are B+. Using the chart below and can figure out the colors codes for all of the wires;
Example - WY = White/Yellow
N = Brown
B = Black
W = White
K = Pink
G = Green
R = Red
Y = Yellow
O = Orange
S = Slate (Grey)
L = Light (e.g. Light Blue, Light Green etc.)
P = Purple
U = Blue
Mark
Last edited by Safari; 03-15-2016 at 01:19 AM.
The following users liked this post:
AustinS '76 XJS (03-15-2016)
#4
See the chart below. The IPR relay is #4 on the "A" relay panel.
Thread
Thread Starter
Forum
Replies
Last Post
sanchez
XJ6 & XJ12 Series I, II & III
12
08-21-2021 08:28 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)