Final drive unit overhaul
Thread Starter
|
Junior Member
Joined: Mar 2011
Posts: 2
Likes: 0
From: Denmark
Final drive unit overhaul
Hi, I'm new in this forum! 
I started to renovate the differential on my XJS 5.3 1984. (2.88:1 ratio) I wnat to change pinion and crown wheel bearings. I need a tool to measure the pinion height. I have measure clock, but missing the target of the round iron block I need to adjust the clock after for adjust pinion height. I would be glad if someone here in this forum which has the height og the iron block så I can make one? Remember that it is a Differential. with 2.88:1 ratio - not a Dana Differential!.
Hope there is someone who can help me
Sincerely,
Per
I started to renovate the differential on my XJS 5.3 1984. (2.88:1 ratio) I wnat to change pinion and crown wheel bearings. I need a tool to measure the pinion height. I have measure clock, but missing the target of the round iron block I need to adjust the clock after for adjust pinion height. I would be glad if someone here in this forum which has the height og the iron block så I can make one? Remember that it is a Differential. with 2.88:1 ratio - not a Dana Differential!.
Hope there is someone who can help me
Sincerely,
Per
Thread Starter
|
Junior Member
Joined: Mar 2011
Posts: 2
Likes: 0
From: Denmark
Well - maybee no one know :-( A little mor inform is. The name on the tool in my Jaguar workshop is "setting block" just like "B" on page 51-5 the rapair operation manual for XJS. Hope still some one can help me 
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
