Help...stuck in Failsafe after accident
Guest
Posts: n/a
Ok...the city put new curbing to seperate the turn lane from the flow of traffic...i didn't realize this and hit it with both drivers side wheels...cracked the wheels and tires are toast. My problem is the car is now displaying: Suspension Failure, Transmission Failure, Engine Failsafe mode, and it's stuck in Valet mode. Is there an inertia switch? how do I reset it everything...? I had it towed back to my place but i don't want to have to go to the dealership ifI don't have to. As far as it is now...i'm needing new wheels and tires...so it's already going to sting a bit.
there is a inertia switch.. left side of dash.(with door open). you will see a trim panel.. in the shape of a "D" pull off and you will see a little black switch push it down. to the left of the fuse box
Guest
Posts: n/a
thanks...worked like a charm...it was to the right of the fuse box though (if anyone else runs into this) I had to put my finger over it and feel for the button...then push it down towards the ground.
Guest
Posts: n/a
well i hit it just right so the brunt of the force was on the lip...think of it as the most wicked case of curb rash...barely any rubber made contact...but i will check it. hey I picked up some wheels for a 2006 xk8...are the offsets and staggering going to be a good fit?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
FS[NorthEast]: 2008 XJ Super V8 - Black on Cream
sg997tt
PRIVATE For Sale / Trade or Buy Classifieds
3
Oct 9, 2015 10:57 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)





