Aftermarket In-Dash Receiver/nav units
#62
Originally Posted by androulakis
Oh and greatoldone if you're still reading, what steering wheel controller are you using, and are there any issues with the lights being on or off with it? I'm using a PAC swi-ps, and it works with the lights on (it was programmed that way) but it wont work with the lights off...
They do do Pioneer link cables for X47:
http://www.incarexpress.co.uk/view_p...partno=PC99PIO
Last edited by greatoldone; 01-31-2010 at 03:59 PM.
#63
http://www.pioneerelectronics.com/St...anual_0507.pdf
It might have same connector harness as d3. I'm not so sure about Ipod tho.
I'm planning to drive down to Blaine next weekend with my family. I'll most like do the installation in the outlet parking lot while my wife is shopping. I will post the pictures when I get back.
#65
The full list of bits for the install are as follows:
Fascia Adaptor: Metra 99-9501
Head Unit: Kenwood DDX8024BT
Steering Wheel Control Interface: Autoleads PC99-X47
Head Unit wiring for Steering Wheel: Autoleads PC99-KEN
Head Unit Wiring Harness Adaptor: Autoleads PC2-81-4 (Ordered by mistake, as you get one of these with the Wheel Controls Interface)
Speaker Wiring Adaptors: Autoleads PC2-815
Ariel Adaptor: Autoleads PC5-100
Speakers: Pioneer TS-H687
iPod Lead: Kenwood KCA-IP301V
Fascia Adaptor: Metra 99-9501
Head Unit: Kenwood DDX8024BT
Steering Wheel Control Interface: Autoleads PC99-X47
Head Unit wiring for Steering Wheel: Autoleads PC99-KEN
Head Unit Wiring Harness Adaptor: Autoleads PC2-81-4 (Ordered by mistake, as you get one of these with the Wheel Controls Interface)
Speaker Wiring Adaptors: Autoleads PC2-815
Ariel Adaptor: Autoleads PC5-100
Speakers: Pioneer TS-H687
iPod Lead: Kenwood KCA-IP301V
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)