I know there has been a lot written about the Symposer Delete and this post is not to resurrect any of those old threads. I have searched through all that I can find and have not been able to track down the 3D Print file for the Symposer block off. I remember a few members had shared their ideas and one had even put the Leaper insignia on it. If anyone has this file or knows where I can find it, can you please let me know?

Thank you for all of your help and I really appreciate all of the information y'all have provided on this site.

 

I have one I can upload to thingiverse if you want it. Doesn't have the Leaper but I could probably add it if you really wanted it on there. Been on my car for a year with no issues.
Jaguar symposer block off plate by gimp - Thingiverse
I think I printed with Esun PLA + but any higher temp filament should work with lots of top and bottom layers if you don't want to do 100% infill.

 

What difference does blocking off symposer do?

 

If you delete the symposer it leaves a big hole in the intake system. Have to block it off for things to work right.

 

What printer did you use?

 

Bambu labs P1S, any decent FDM printer would work though, unless you are looking for the actual printer config file.

 

I am going to print off a couple tomorrow, if anyone wants one, I will ship one to you.
I am printing mine using ABS, kind of overkill. but I do not want to do it again.

 

PM sent

 

i would be interested in one if possible. Sending you a message

 

Was only printing 3, so @Craaaazzy and @Rondog I will send you one each, also replied to your messages.

Randy